0
When the engine is hot
.008 intake
.012 exhaust
or
.007 intake
.011 exhaust
When the engine is cold
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you test the ignition coil on an '86 Toyota pickup 22re?
get a volt meter. turn it on. put one end on the +. the other end on the -. if you get a number greater than 12 with the car running then your golden.
What is a normal heart rate for a chihuahua?
86
How long has Claude Monet been dead?
he is 86 years old because you subtract 1926 with 1840 and you get 86 becaude he was born in 1840 and died in 1926.
How many subatomic particles does radon have?
Radon has 86 electrons and protons; the number of neutrons is specific for each isotope. Number of neutrons in a radon isotope = Mass number - 86
Whats wrong when an 86 ford aerostar keeps trying to start after the engine is running?
Whats wrong when an 86 ford aerostar keeps trying to start after the engine is running?
Is an 86 Toyota 22RE motor a non-interface engine?
yeah It is
What is the firing order for a 86 Toyota 22re 4 cylinder?
1342
What is the head bolt torque specs on a samurai?
Head bolt specs for the '86 Samurai are 46 to 50.5 in. lbs.
Where on the web can you find ignition timing specs for an 86 Chevy 305?
try autozone.com
What are the cylinder head torque specs for 86 Yamaha radain?
The cylinder head torque specs for a Yamaha Radian is 35.61 Nm. You can also say the specs are 3.6 kgf-m and 26.3 ft.lbs.
What sizes are the nuts for the Down pipe that connects to the manifold on a 1988 Toyota 4Runner?
I have an 86 4 runner and a 22re engine. The nuts and bolts on mine are 12 mm.
Where at on a 86 Chevy Celebrity is the PCV valve?
The PCV sits in a rubber grommet in the top of the valve cover.
How do you gap the piston rings on a 86 cutlass?
You will need feeler gauges, a ring spacer and separation tool, the correct specs for their correct placement on the piston and the gap specs.
Where can you find the PCV valve on your 86 Caprice Classic?
The PCV Valve is usually located on the valve cove, driver or passenger side, towards the front of the car.
I put a head from an 85 4x4 Toyota on my 86 2wd pick-up but the head is a 14 of an inch to tall an now my timing chain is too short how can i use this head?
you cannot use that head you will never get the timing in engine right The head of an 85 4x4 is the same as on 86 2wd pickup are the same on 22r or 22re. the only difference is the fuel pump has been capped off for the 22re. You probably got the head from a 4x4 with a different engine.
What is the valve clearance on a Honda 125 86?
.07mm or .003 inches cold.
Where is the crank case vent on an 86 Chevy 350?
Usually it vents from the valve cover.
