answersLogoWhite

0

It depends on the kind of vehicle. If it's a Ford, you might just need a solenoid. Some fords have an external solenoid, mounted on the drivers side wheel well. Some vehicles have a solenoid integral to the starter. In those you might need a starter.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Diesel engine will not kick over but plenty of battery power?

if it wont crank the the starter is probally out but if it cranks and the motor doesnt turn either the belt is to loose or the engine is locked up


If a battery cranks well can it still be bad?

If the battery turns the engine over as it should then the battery is good.


How do you reset a Kia Sedona check engine light?

You have to disconnect the negative battery for 5 min then unhook the positive then re hook the battery this should take care of the pesky engine light if it doesnt then u have to get the code


Your engine does not crank when you turned on the engine but when you connect the solenoid to the battery the engine cranks?

Sounds like you might have a bad starter relay.


I have replaced the alternator starter and the solenoid on my 1991 Ford Ranger and when you disconnect the battery cable it kills the engine. What else can be wrong?

Never disconnect a battery while an engine is running!


How do you clear engine codes?

disconnect battery for one mi.


Do you have to disconnect a battery before charging?

No, you do not have to disconnect the battery. Just do not start the engine with the charger connected unless the charger is built for starting purposes.


On a boat motor when you disconnect a battery cable should the engine stall?

No.


How do you change the battery cables on a 1990 Olds Cutlass Supreme 3.1 engine?

disconnect cables from battery. follow pos. cable to starter and disconnect. follow neg. cable to end disconnect bolt mounted to engine. good luck. hamsandwich


How do you turn off the check engine light on a Saturn L200?

Disconnect the negative battery cable for about a minute Disconnect the negative battery cable for a minute or so


Why doesnt your 92 dodge dynasty start the engine cranks but will not start battery was replaced no success it will start with a spray of starter fluid down the carb but will die shortly after?

You may have a fuel problem, check the fuel filter and fuel pump.


How do you take out EGR valve out of Previa 1991?

disconnect battery, disconnect the starter, disconnect the starter mount bracket from the engine and you can access the egr valve no need to lower the engine good luck