rear drivers side then other rear wheel then front drivers and finally passenger front , just done my daughters worked a treat
Remove the bolts. Its as simple as that!
The starter relay is in the fuse case under the codriver's cabinet. The exact is the one that contains the numbers 38, 72, 36 45, 52. Alien
there are everal symbols, battery, handbrake,airbag, if its diesel you'll have a coil heating light, oil low indicator, headlights,sidelights,mainbeam
You remove the speedo cable and drive and fill up the oil through the hole then refit the cable. It is held in bt a 9mm bolt and a plate.
Check the Skoda windshield for leaks. Also check the firewall where ant wires or hoses come through for any possible leaks.
The Skoda Felicia is a compact car made by Skoda Auto. Its weight is between 960 kilograms and 1,060 kilograms.
torque setting for cylinder head bolts for a skoda felicia
It pumps water.
in the fuse box
For a 1999 Skoda Felicia, the torque setting for the cylinder head bolts is typically around 20 Nm (15 lb-ft) for the initial stage, followed by a further tightening to 90 degrees in a specific sequence. The tightening sequence generally starts from the center of the head and works outward in a crisscross pattern to ensure even pressure. Always consult the vehicle’s service manual for the exact specifications and sequence, as variations may exist based on the engine type.
need settings
Castrol 10W40.
Hammer
needs programmed
at fuel tank
When tightening the head gasket on a Skoda Felicia, it's essential to follow a specific sequence to ensure even pressure across the gasket. Generally, you should start from the center bolts and work your way outward in a crisscross pattern. The final tightening should be done in stages, typically starting from a lower torque specification and gradually reaching the manufacturer's recommended torque. Always refer to the vehicle's service manual for the precise torque values and tightening sequence specific to the engine variant.
13cm