Remove the bolts. Its as simple as that!
Move the seat all the way forward then remove the nuts or bolts from rear. Move the seat all the way back then remove the front nuts or bolts. Tip the seat back and disconnect the electrical plug(s). Remove the seat from vehicle.
'96 Explorer Seat Belt Replacementhttp://www.seatcoverset.com/seatcovers-car_seat_cover.htmIn order to replace the driver side seat belt on a '96 Explorer, you must completely remove the drivers seat. Removing driver side seat belt: Use a 10mm socket/wrench to remove the two bolts securing the front of the seat to the floor. Move the seat as close to the steering wheel as possible to expose the rear of the sliding seat rails. Pop off the two covers at the end of each rail to expose two more 10mm bolts securing the seat to the floor. Next, remove the plastic cover with a Torx symbol on it at the rear of the seat belt guide rail. Removing the aforementioned cover will allow access to a large Torx bolt just below the rear of the center console. Remove this large Torx bolt, unplug any electrical wires below the seat, and remove the entire seat from the Explorer. With the seat out, you can use the same Torx wrench to unscrew the seat belt itself from the seat. Reassembly is the opposite of disassembly.
The center seat is removable, after which the rear seat can be slid forward.
Underneath the drivers side seat, under the carpet.
Unbolt it from the floor.
in the tank,remove rear seat swab,undo small plate pump under plate
To replace the fuel pump in a 1999 Skoda Felicia, first ensure you disconnect the battery to avoid any electrical issues. Next, access the fuel pump by removing the rear seat and the fuel pump cover. Disconnect the fuel lines and electrical connectors, then unscrew and remove the old pump. Install the new pump by reversing the removal process, ensuring all connections are secure before reassembling the seat and reconnecting the battery.
Remove seat!
Remove we beetle seats
Remove drivers seat by lifting tab on front of seat.
the size that fits...
remove the passenger pad first, when removed it uncovers screws on the rear of the drivers seat. Remove these and it comes off.
There are 4 mounting bolds that hold the seat to the floor. Remove them. Pay attention to any wiring attach to the seat.
there should be 4 bolts that hold the seat to the floor. just remove them and if it has power seat dont forget to unplug them.
Remove the four bolts that secure the chair. Tilt the seat forward using a lever. Hold the chair from the back and remove it.
Machete.
if rear side door; unlock and pull handle. if boot lid; pull handle in drivers side door-well (side of the drivers seat) "door open"