0
It is located between the back of the engine and the transmission. It houses the flywheel and clutch if it is a standard or the flex plate and the torque converter if it is an automatic transmission.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is the difference between an intigrated bell housing and the non intigrated bell housing for a 5 speed manual transmission on the 1994 Chevy 4x4 diesel pick up?
An integrated bell housing means it is part of the transmission assembly and can't be removed from the transmission. A non integrated bell housing allows the end user to remove the housing from the transmission usually by unbolting it.
I have an old Ford bell housing D9TA 7505-BA Can anyone tell me what type of housing this is and what applications it will fit Thanks?
fits 351m engine
Are all 4l60e transmissions the same?
No, Starting in 1999 GM. changed the bell housing design.
Where is the starter on a 1966 mustang?
Lower rear passenger side of engine, bolted to the transmission bell housing.
Where is the starter on a 1993 Blazer 350 engine?
The starter location on all Dodge Dakota engines is on the driver's side rear of the engine, low down and bolted to the transmission bellhousing. It will be cylindrical in shape and the positive (red/+) battery cable will run directly to it.
Is a 460 bell housing and a 6.9 diesel bell housing the same?
No it is not
Where is the bell housing on a Jeep?
The bell housing is the part of the transmission case that bolts to the engine. The bell housing contains the clutch or torque converter.
Where is crank shaft sensor located on a 1997 Jeep Grand Cherokee?
4.0L, driver side top of the bell housing.5.2L, passenger side top of the bell housing.4.0L, driver side top of the bell housing.5.2L, passenger side top of the bell housing.
Where is the bell housing on an 1994 jeep Cherokee 4.0?
The bell housing is the front part of the transmission where it bolts to the engine. The bell housing surrounds the torque converter and flywheel.
The clutch went out in your 2001 eclipse gt and you can't get the transmission to break free from the bell housing Any suggestions?
why would you want to braek the bell housing free from transmission ? the bell housing needs to be removed to replace clutch, so remove bell housing and transmission as one unit.make sure starter motor is removed. usually blts the secure bell housing and transmission toether can only be reached from inside bell housing after bell housing and transmission are removed from vehicle
Where is the bell housing on 1999 dodge ram truck 5.2L?
The bell housing is the front of the transmission, the end that bolts to the engine.The bell housing is the front of the transmission, the end that bolts to the engine.
Where is a bell housing on a 1999 grand Cherokee Laredo?
The bell housing is between the engine and the transmission.
Will a ford 302-351w bolt to a 300 six cyl 4 speed bell housing?
The Ford 302 engine will not bolt to the 300 six-cylinder bell housing. A new bell housing or a Bell housing modification kit will need to be used.
Where is the clutch slave cylinder located on 1993 jeep cherokee?
Inside the bell housing.Inside the bell housing.
Where is the bell housing for a 2000 jeep Cherokee 4.7?
The bell housing is the front part of the trans that goes around the flywheel.The bell housing is the front part of the trans that goes around the flywheel.
Will a 97 plymounth voyager 3.3 tranny work on a 97 plymouth voyager3.0?
No, the bell housing pattern is different.No, the bell housing pattern is different.
Where the hole in the bell housing to timing a c12 cat engine?
The hole in the bell housing, on a C12 Caterpillar diesel engine, can be found on the bottom of the bell housing. The hole faces straight down.
