answersLogoWhite

0

It is obvious you have previously used an epoxy pool paint. Epoxies are good and they do last. Only negative is that they are not UV resistant and chalking is a natural phenomenon. Next time try a better quality and a light colour No need to shot blast again.

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Art & Architecture

What if your service traction system light ABS light Traff off light keep coming on and at the same time there is resistance when you press the brakes you have a 2004 Pontiac grandprix?

Might be a bad wheel bearing assembly


Why is the Security light on in a 2001 Chevy Blazer that doesn't even have a security system?

The 2001 Chevy Blazer does have an ignition security system that is controlled by the computer in the vehicle. The light might come on because of an error that is coming up in the computer due to a key problem or an ignition problem. This is a common issue with the 2000 and 2001 Blazer.


Why does the theft system light keeps coming on. It's a 1997 Pontiac sunfire why?

I have the same problem with my 2004 Sunfire. Leave the ignition on for 10 minutes. Just let it sit for 10 minutes. No shorter than that time. And Should start.


How does blood leaving the lungs differ from the blood entering the lungs?

Blood coming from the lungs has lower pressure while that from the heart has higher pressure. Blood coming from the lungs also has higher oxygen content and lower carbon dioxide content compared to that coming from the heart.


How do you clean a stain off concrete?

OK, that is stamped concrete. things you don't want to use are a pressure washer. It will blow the release color off the concrete and destroy the area you are trying to save. first you will want to remove any sealer on the the affected area, you can do this with xylene (you can get it right at home depot) this won't hurt the concrete or the color, and will re liquify the sealer (if it is a topical sealer) once you have use the xylene clean the area with denatured alchohol to remove any residule sealer, once you have done that scrub with a non caustic cleaner such as simple green. if the stain still remains your best option is to contact somone experienced in concrete and have them remove the small stained area and replace it. I did stamped concrete for years so i know what i am doing with this. if i saw this i would do the things i said and if it didn't ome clean i would use a grinder to remove the small section that is orange and then repour it using a high psi mix hand tinted (id mix and pour samples at home first to verify the correct color to concrete ratio) and then just use a small edge stamp to redo the texture.

Related Questions

What services does Concrete Work provide?

Concrete Works provides insulated concrete forms, traditional concrete foundations, test pits and evaluations. They also do septic system repair and installation.


Is radiant flooring an option if you have an existing concrete floor?

Radiant flooring is an option if one has an existing concrete floor. The radiant flooring system is installed underneath the concrete floor to heat the concrete.


What has the author Chester W Jones written?

Chester W Jones has written: 'Frost penetration beneath black-painted concrete canal lining' -- subject(s): Canals, Frost heaving, Concrete construction, Cold weather conditions 'Closed-system freezing of soils in linings and earth embankment dams' -- subject(s): Plants, Earth dams, Frost protection


What does it mean when the alarm sounds on your concrete septic system?

something broke


Where can you find ''jesus is coming again'' in Dewey decimal system?

232.6 (Second Coming)


What is the best flooring option for uneven concrete surfaces?

The best flooring option for uneven concrete surfaces is self-leveling concrete or a floating floor system, such as laminate or engineered hardwood. These options can help create a smooth and level surface over the uneven concrete.


Can a copper hot water line heat the concrete slab?

When installed properly and correctly, a copper line from heating system can be used to heat concrete slab.


What is F2 formwork?

F2 formwork refers to a specific type of formwork system that is commonly used in the construction industry for creating concrete structures. It is a modular system made of steel or aluminum frames that can be easily assembled and adjusted on-site to form the desired shape of the concrete structure before pouring concrete into the mold.


What has the author David C Stark written?

David C. Stark has written: 'Effect of vibration on the air-void system and freeze-thaw durability of concrete' -- subject(s): Concrete, Effect of temperature on, Vibrated concrete


What system did Napoleon develop to boycott the goods coming from Britain?

The Continental System.


Can we have an alternative method or system to concrete pour cards?

pour card poor or fare


Where should I go for reliable concrete test equipment?

Forney Materials Testing performs concrete tests and also sells their own specialized concrete test equipment. Admet Materials Testing System has very reliable concrete test equipment. You should look into their products and services.