answersLogoWhite

0

The 2000 Ford Explorer front hub nut has a torque specification of 140 pounds of pressure. The hub should not be over tighten. Over tightening can ruin the seal.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Do you have to remove the transmission in a 92 aerostar awd with a a4ld transmission the van to replace the leaky front seal?

yes , because the seal is behind the torque converter


Where is the starter located on a 1995 AWD Ford Aerostar 4.0?

attached to the transmission on the bellhousing.


1995 Ford Aerostar water pump removal V6 3.0L non AWD?

Removal of the water pump on a 1995 Ford Aerostar V6 3.0 non AWD begins by removing the drive belts and accessories. The water pump can then be unbolted and pulled from the engine.


Will a 4.0 liter engine and transmission from a 1997 awd aerostar fit a 1992 awd aerostar?

( No ) the 1997 Ford Explorer uses automatic transmissions that are ELECTRONICALLY controlled , where the 1992 model year is not ( P.S. I'm not a mechanic / technician )


What is the front spindle nut torque spec 1997 explorer awd?

157 to 213 ft-lbs.


How much transmission fluid does a 1994 Ford Aerostar AWD hold?

A 1994 Ford Aerostar manual transmission will hold 1.2 liters of API GL-5 SAE 80W90 transmission oil. An automatic will hold 10 quarts if the lines are completely flushed.


Is there anyway to get the starter out of a 1990 AWD Aerostar without removing the exhaust?

No, there isn't sorry.. on 1997 awd aerostar 4.0 you have to take four bolts off of front drive shaft ,pry it away from the coupling ,may need some persuassion (pry bar and hammer) .move drive shaf up and out of the way and the starter will have enough room to slide down.


How do you replace the egr valve on a 1995 Ford Aerostar 4.0 engine?

My 4.0 awd aerostar does not have an egr. If you have pinging,and done all the usual tune up stuff, try putting in spark plugs from the 3.0 engine. the different reach range cured my pinging!


How does awd work in gmc acadia?

The Acadia AWD system is set up to deliver a 90/10 torque split (90% to the front wheels) in normal operation. When detecting front wheel slippage it can transfer as much as 35% to the rear wheels. So on a steep incline it would indeed be better than FWD. Not much sense to have an AWD system that delivers all torque to only one differential as the previous poster seemed to indicate.


Are all Expedition 4x4's AWD?

All 4x4's Ford Expeditions are not AWD... I have a 1998 Ford Expedition XLT and it has (2H/AWD/4L/4H). But, my brother has a 2000 Ford Expediton EB (AWD/4L/4H).


What is the difference between a 4x4 and awd ford escape?

AWD= All wheels pull all the time, but in a 4x4= its a rear wheel drive until the driver choses to ingage the front axel.


What causes thumping noise in front end of 96 ford explorer awd?

the noise coming from this truck is the uv goints