answersLogoWhite

0


Best Answer

At this point I would do a compression check. If you find a cylinder 15% or more lower than the rest you probaby have a valve problem in that cylinder.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is wrong with your 76 Ford f100 that is skipping I have installed new wires plugs rotor button and distributor cap.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1994 prism with no spark you have installed anew distributor and still nospark at plugs?

Coil?


Why must the engine be set at TDC before removing the distributor?

Because the replacement distributor and spark plugs wont fire correctly if it installed in any other position.


What causes a rotor button to burn up frequently?

To much resistance in the spark plug wires. Start fresh with a new distributor cap, rotor and spark plug wires. Also be sure you have the correct spark plugs installed.


Can a bad distributor cap rotor button wires and plugs stop car from starting?

Yes, any of those can cause a no spark problem.


1992 Chevy truck misfiring?

probably needs tune up. plugs, wires, distributor cap, rotor, button, maybe coil


1995 Chevy s-10 Blazer Why I have fire from distributor to coil but no fire from new coil to plugs?

The spark travels from the coil to the distributor then from the distributor to the plugs. So if you have spark going into the distributor but not coming out to the plugs, I would blame the distributor cap and rotor being at fault.


No power from distributor to spark plugs?

My 93 camry has no power from the distributor to the spark plugs. The car unable to start.


What does and electronic ignition do?

An electronic ignition tells the spark plugs when to fire to ignite the fuel. In older cars this was done mechanically by means of a distributor and rotor button.


Why does it take 5 or 6 cranks to start your 89 ford f 150?

check/change the ignition components(plugs, wires, distributor cap, rotor button)


I'm not getting fire to the spark plugs.?

Have you checked all of the High Tension leads from the distributor to the plugs, or just one or two? Same with HT lead from Coil to Distributor, Check Distributor cap for cracks


Why am I getting fire to everything on 305 engine except the plugs?

If it has a distributor, check the rotor button for a burn mark underneath. The high energy coil will sometimes burn a hole through it causing the fire to ground. Replace rotor button.


Why would a 94 jeep grand Cherokee have good fuel pressure no spark?

I would replace distributor cap & rotor button, plugs & wires, and if necessary distributor. Also, check your ignition timing, if you broke a timing chain you wouldn't have any spark.