The oil drain plug uses a 13 mm wrench.
The 1992 Dodge Ram 150 spark plug gap is .035 inch.
Move the steering shaft. There is one bolt under the plastic cover. This is the pinch bolt .Remove it and slide shaft towards firewall ,move shaft out of the way ,replace plug,re-install shaft,bolt and plastic cover.
#1 on the distributor cap of a Dodge 360 faces to the front - inline with the center of the engine ( according to the picture in my Chilton repair manual )
The oil drain plug on a 1999 Dyna Wide Glide is located on the bottom of the engine. It is on the right side of the engine.
This is a specialist job and needs to be handeled by one, Sometimes the head needs to come off. Take it to a garage.
The plug is on the outside of the frame.
in the oil pan
My 2008 Dodge Charger R/T has an auxiliary jack in the stereo.
They will bolt on but the electronics may not plug in.
It is the rear driver side.
Underneath the truck on the oil pan.
The plug gap spec is .050 inch.
If the 8th digit in the VIN are the same, then yes It may bolt in but the sensor plug ins are different.
It takes a 17mm Allen wrench to remove the fill plug.
you can find the drain plug in the center of the oil pan
It is on the back of the transfer case, takes a 10mm Allen wrench to remove.
Number three is the rear passenger side.