Make, model and year would help.
Remove the wiring harness from the back of your headlight assembly. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.
You have to remove the front grille, and then remove the headlight itself and then you can access the bulbs by un-clipping the 2 retaining clips and removing the rear cover.There is an excellent video of how to do this on youtube:http://www.youtube.com/watch?v=arRJkRpC9bo
Begin by removing the decorative radio retaining cover. Remove the retaining bolts. The radio will slide out. Remove the wiring harness and the antenna cable from the back of the radio.
There are 4 little screws around headlight, remove then unplug and replace. Vdubwizard
it is located on right front of block. First remove your fuel lines, the remove the retaining bolts holding it on the pin will slide out after the pump. coate the pin with grease and reinstall in its hole(grease will hold it for you so you can get the pump in) the install pump and lines
Remove the headlight wiring harness. Remove the headlight retaining bolts. Each headlight has four retaining bolts. Reverse the process to install the new headlight.
Remove the headlight retaining bolts. The retaining bolts can be access through the engine compartment. Remove the wiring harness. Reverse the process to install the new headlight.
Begin by removing the wiring harness from the back of your headlight. Remove the headlight assembly retaining bolts. The headlight assembly will come out.
The bulbs are removed from the back and just turn out counterclockwise.
Remove the wiring harness from the back of your 2007 Chevrolet Corvette headlight. Remove the headlight retaining bolts. The headlight will come out and can be replaced.
You can remove the headlight by removing the retaining screws. Remove the headlight wiring. The headlight should easily come out.
Remove the retaining screws from the headlight assembly. Remove the wiring harness from the back of the headlight. The headlight will come out. Reverse the process to install the new headlight.
remove the retaining screws. pul oyt headlight and unplug it. plug in the new one and replace the retaining screws.
Turn it
Begin by removing the wiring connector on the back of the headlight. Remove the headlight retaining bolts. The headlight will come out.
Remove the wiring harness from the back of the headlights. Remove the headlight retaining bolts. Remove the headlight. Reverse the process to install the new headlight.
# Disconnect negative battery cable # Remove the retaining screws and detach the headlight bezel # Remove the headlight retainer screws taking care not to disturb the adjusting screws # Remove the retainer and pull the headlight out enough to allow the connector to be unplugged # Remove headlight now # Disconnect negative battery cable # Remove the retaining screws and detach the headlight bezel # Remove the headlight retainer screws taking care not to disturb the adjusting screws # Remove the retainer and pull the headlight out enough to allow the connector to be unplugged # Remove headlight now