To replace the headlight housing on a 1992 Ford Tempo, you will first need to access the back of the headlight assembly by opening the hood. Locate the retaining clips or screws holding the housing in place and remove them carefully. Disconnect the electrical connector from the back of the headlight bulb, then remove the old housing and replace it with the new one. Secure the new housing in place with the retaining clips or screws, reconnect the electrical connector, and test the headlight to ensure it is working properly.
The first thing to do is go and buy the replacement bulb. Behind the headlight there is a round ring unsrew it pull out the bulb (which is attached to the wires). When you look at the old bulb base and your new replacement you will know what to do. Just unplug the old bulb housing and plug in the new.Putting the round ring and bulb housing back on can be a chore but it just just takes a little time.
what is the year of this van 2002 or 1992?
on a 3 cyl.metro,the iat sensor is found on the air cleaner housing towards the rear of the assembly
The 1992 Chevy 3500 temperature sensor is located on the front of the engine. The temperature sensor will be in the vicinity of the thermostat housing.
If the reservoir is blocking the way, then it will have to be removed.
To replace a thermostat on a 1992 Geo Storm first locate the its housing. Once found drain the coolant system and remove the housing from the engine. Replace the thermostat.
I found the answer at http://autorepair.about.com/library/faqs/b1103f.htm
You can go to Wal mart and ask the sales associate
To replace the headlight on a 1992 Subaru SVX, first, open the hood and locate the headlight assembly. Remove the screws or clips holding the assembly in place, then gently pull it out. Disconnect the electrical connector and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the electrical connector, and reattach the headlight assembly. Finally, test the new headlight to ensure it works properly.
if you lift the engine hood there should be 4 nuts by where your headlight bulb fits into the housing.they should be size 12mm nuts.just remove those 4 nuts and the headlight bulb retainer(you remove that by twisting counter clockwise) and your headlight assembly should pull right off
Bel Tempo ended in 1992.
To replace the headlight on a 1992 Acura Vigor, start by opening the hood and removing the screws or clips securing the headlight assembly. Carefully pull the assembly forward to access the back, disconnect the wiring harness, and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the wiring, and then reposition the headlight assembly, securing it with the screws or clips. Finally, test the new headlight to ensure it’s functioning properly.
Where is the headlight relay in 1992 Mazda Protege?"
what kind of fule pump is in a 1992 ford tempo
To replace the headlight switch on a 1992 Toyota Previa, first, disconnect the negative battery cable to ensure safety. Then, remove the dashboard panel surrounding the switch, typically by unscrewing or unclipping it. Next, detach the wiring harness from the old headlight switch, unscrew it from its mounting, and replace it with the new switch. Finally, reconnect the wiring harness, reassemble the dashboard panel, and reconnect the battery.
Please see the same question on the 91 Capri. The procedure is the same.
special tools are required to do this job.slide hammers impact tools.yhis is not a job for diy!!