Sealed suspension system from factory replacement parts have grease fittings..........^ NOT MUCH OF AN ANSWER TAKE THE TIRE OFF THE FRONT WIPE OFF EXCESS GREESE WITH A STICK OR BY HAND LOOK FOR THE SMALL NIPPLES ONE FOR SURE IS ON THE TIRROD END THE ROD THAT TURNS THE TIRES NOT EVERYTHING IS SEALED
It probably hasn't any.
most newer vehicles comes with plugs you have to remove these and buy the grease fittings and screw them in yourself. very easily done. they require a 5/16 open end wrench to remove. very inexpensive also.
On the blade spindles, the fittings are just above blades under the mower deck. You'll need to remove the deck and flip it over (careful doing this, heavy and sharp). There are two more on the inside of the front axle, visible when looking at front wheels. These seem to be good mowers if you take reasonable care of them.
Should have 11. Upper and lower ball joints (4), outer tie rod ends (2), inner tie rods ends (2), idler arm (2) and pitman arm (1).
The song "Grease" written by Barry Gibb and performed by Frankie Valli, the theme from the movie "Grease," is controlled by Crompton Songs and administered by Warner-Tamerlane. Various sound recordings would have their own additional copyright holders. The TV show "Grease is the Word" is property of Syco TV.
no
where are the grease fittings on2007 polaris 500 sportsman located
The year and model would help.
The G5 doesn’t come from the factory with grease fittings but that doesn’t mean that yours doesn’t, a lot of people will change there old worn bushings with new bushings that have grease fittings!
There are not any.
Origional equipment components will not have any grease fittings. Once you replace the parts with GOOD aftermarket parts you will have fittings to lube. You should get a few years out of the original parts before they need replacing
It doesn't have any.
There are no grease fittings, they are sealed units. If a part wears out the replacement part will have grease fittings if required.
Factory unit is sealed without grease fittings Replacements have grease fittings
The original parts had no grease fittings.
they dont have any.they are maintenance free.
11 grease fittings