The crankshaft position sensor is behind the catalytic converter, in the area where the engine mates to the transaxle. Access is from below, and you should wait for it to cool down. This answer is specific to the DOHC 2.0L Zetec engine.
Im new to the eclipse game, but my eclipse had the same problem. Are you getting fire to the coil. If not check the sensor on the back of the motor under the intake, possibly the throttle position sensor, im not sure what the name is but it works, i promise.
I have the same problem on my Mitsubishi Eclipse RS 1995. Seems to be a problem in Map sensor. I was also told it might be the ECU
The 2004 Mitsubishi Evolution fuel temperature sensor can be found on the top of the gas tank. The fuel temperature sensor will be near the front of the gas tank.
the cam position sensor and ignition coil are inside the distributor. the crank position sensor is located on the bottom front of the engine, behind the belts on the left side.
It is called a APPS accelerator pedal position sensor. It is located on the front of the engine. It is the part that the throttle cables hook to.
where is the camshaft position sensor located on a 2001 mitsubishi eclipse v6
On you car.
Found it at front bottom of engine
The 1995 Mitsubishi Eclipse crankshaft position sensor is located on the back of the engine. The crankshaft position sensor will be near the bottom of the engine cover.
where is located theknock sensor 97 mitssubishi eclipse
The vehicle speed sensor is located on the transaxle
where is the speed sensor located on a 95 eclipse 5 speed
The crankshaft position sensor is located on the front of the engine inside the timing belt cover
Crank position sensor is located next to the crankshaft. In order to replace it you might have to remove the timing belt. In the most models you just can remove remove the timing belt cover and replace the sensor.
left side of the intake manifold.
turbo or non turbo?
behind the crank shaft pully and the timing cover and then another pully is there two bolt hold it on