the ports are the awkwardplate looking thing on the top those are the ports. the egr valve itself is located next to the distributor. it has a grey plug and a vaccum hose attached to it and it is bolted on to the manifold with two 12mm nuts. it is possible to take off withought removing intake manifold. clean with choke cleaner and a brush, suggestions also run seafoam through throttle body and try to use every 6 months i was told to help clean ports
on the intake manifold you should see a vacuum line coming from it connecting to youe throttle body
The valve located at the entrance of the R.V. is the Tricuspid Valve. The valve located at the entrance of the L.V. is the Bicuspid or Mitral Valve.
Remove EGR valve and inspect for blocked or restricted passages.
The ORVR valve in a Toyota Camry is an on-board refueling vapor recovery valve. This valve is located in the upper portion of the fuel tank.
The bicuspid valve is located between the left atrium and the left ventricle
It is located on the top of the valve cover towards the rear of the engine.
where is the purge soleniod on 1999 acura tl
The 1991 Acura Integra idle air control valve can be found on the firewall. The valve will be on the drivers side of the firewall.
Yes, clean the cabor buildup from the EGR valve and that pipe.
located in the top of the drivers side valve cover between the front and mibble coil.
drivers side head
the EGR valve is just under the distributor cap
The PCV valve on the 2001 Acura TL is located on the top of the rear valve cover. It's easy to replace - simply pull it out by hand and remove the attached hose. You have to remove the black plastic cover on top of the engine to access it.
egr valve is located approx 1 foot left of centerline when facing the car and has large paperclip looking device on top
You also need to clean the "passages". EGR valve puts exhaust gas back into the engine intake under less than full power situations. When that happens exhaust deposits build up on the walls of the passages. Replacing the EGR valve was only half the repair, you also need to clean it out. There is a tube from under the EGR valve to the exhaust manifold. That is probably blocked.
With hondas always clean the valve and passages before replacing the valve it is probably just carbon build up restricting flow and throwing a code. This is a very common problem.
You need to replace your IAC Valve (Idle Air Control Valve) It's located in the back of Your Intake Manifold.