answersLogoWhite

0

On the rear wheeels. some have a special drum inside the rotor and some use the caliper.

User Avatar

Wiki User

20y ago

What else can I help you with?

Related Questions

How do you install brake pads for Isuzu rodeo 2000?

How to Install Front Brake Pads Check Related links below.


How do you replace the shocks on a 1997 Isuzu Rodeo?

How do I remove the front shock bottle pin of my Isuzu rodeo 2000


How do you adjust the headlights on a 2000 Isuzu Rodeo?

how do you adjust head ligths up or down on a 2001 Isuzu rodeo


Will a 3.5L 1998 Isuzu Trooper engine fit on a 3.2L Isuzu Rodeo transmission?

will a 3.2L 2000 Isuzu Trooper engine fit a 3.2L Isuzu rodeo transmission


What weight oil for 2000 Isuzu Rodeo?

10w30


Would it cost more to insure a 2004 Isuzu Rodeo or a 2000 Ford Mustang?

The 2004 Isuzu Rodeo is $ 136.00 more where I am


Where is the solenoid on 2000 Isuzu Rodeo located?

its built into the starter


What size gas tank does a 2000 Isuzu rodeo have?

A 2000 Isuzu Rodeo has a 21.1 gallon fuel tank. The estimated fuel economy is 8 mpg city, and 21 mpg highway.


Radio unlock code 2000 Isuzu rodeo?

the code is 756235


Is Isuzu Rodeo 2000 3.2 v6 motor an interference motor?

Yes , according to the Gates website ( they make timing belts etc. ) the 3.2 liter V6 in a 2000 Isuzu Rodeo is an interference engine


Will 2000 Isuzu Rodeo engine fit a 1999 Isuzu Rodeo?

Yes, a 2000 Isuzu Rodeo engine can fit into a 1999 Isuzu Rodeo, as both models share similar engine configurations and components. However, it's essential to verify compatibility regarding the specific engine type and any potential differences in sensors or wiring harnesses. Always consult a mechanic or service manual for precise details before proceeding with the swap.


How do you replace the brake light for a 2000 rodeo Isuzu?

To replace the brake light on a 2000 Isuzu Rodeo, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips holding the assembly in place and gently pull it out. Twist the bulb socket counterclockwise to remove it, then replace the old bulb with a new one, ensuring it's securely fitted. Finally, reassemble the tail light by reversing the steps and test the new brake light to ensure it works.