On my 97 legacy it is (looking from the front of the vehicle) located to the rear and right of the throttle body. I was able to find it by removing the inter-cooler. and a couple of hoses to get to the thing. I first saw the white wire connection and followed it down. Everyone kept telling me it was there but I did not believe it after searching for days; but it was there all the way down on the block. Get a flashlight to shine down there as you trace its connector. Will need a long extension to undo the small bolt that hold it down..
Remove the oil line from the Turbo. Remove the temperature sensor from the Turbo. Remove the Turbo retaining nuts. Replace the old Turbo gasket with a new gasket. Reverse the process to install the new Turbo.
12 psi in both ranges
on the pipe that leads into the inlet manifold from turbo, the one with a metalic wire when you take it out
Turbo is meaning for fast. Like my dog's name is Turbo, and he is very fast!!!!
Lots of things-bad oil pressure, restriction in the oil drain tube on the turbo, excessive crankcase pressure, and a worn turbo can cause turbo smoke.help@coloradoturbo.com
The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.
as far as i am aware it is on the maf sensor, still looking into it
The MAF sensor is located on the intake pipe where it exits the air filter box.
the knock sensor is located on the driver side of the engine right under the intake it is about 1 in. it is connected so you will have to unplug it and then just screw it off
if you mean the lambda sensor it could either be located just after the turbo or it will be on the up pipe to the turbo its all according which model you have but just unplug it and unscrew it and replace it and then plug it back in.
underneath the intake plenum near the rear of the engine.
17.4 ft-lb. - and make sure you put it back at the same angle the old sensor was.
no
The knock sensor on 90-96 300ZXs is located between the engine block and lower intake manifold. please if you want to know where anything is at on a 300ZX visit www.ttxtz.com
yes, Subaru or aftermarket.
I had this issue on a subaru forester turbo.. tunred out to be my fuel pump I had this issue on a subaru forester turbo.. tunred out to be my fuel pump
The subaru impreza wrx does indeed have a turbo. As subaru would have you know, that is the whole point of a wrx To get an answer faster, check subaru's website next time. I took me about 20 seconds.