0
What else can I help you with?
Easiest way to remove oil pressure sending unit on 1997 Chevy PU 350 behind distributor?
The easiest way would be to purchase the special socket that fits that sending unit to remove and install.
Where is the oil sending unit on a 1997 Dodge Dakota?
The 1997 Dodge Dakota oil sending unit is in the oil pan, on the bottom of the engine. You will need to remove the oil pan in order to view the sending unit.
What would cause your oil light to malfunction?
Defective oil sending unit, blown bulb.
Is it safe to drive your car if the oil sending unit is out?
yes.if you know you really have oil pressure.
Awhere is your temp sending unit on your 1990 Tpi 350?
Below the water neck on the front of the intake.
How do you install a mechanical oil pressure gauge on Chevy 350?
Screw out the oil sending unit. Put a "tee" back into the hole. Screw in the oil sending unit for the light AND the fitting for the mechanical oil gauge.
Where is the oil sending unit on a 98 silverado with a 350 engine?
it is located at the rear of engine block by the distributer.
Where is the oil pressure sending unit located on a 89 Chevy 350?
At the back of the block, near the distributor.
Where is the oil pressure sending unit on a 1992 chev 350?
Top rear of engine, close to the distributor.
Where is oil sending unit on 1996 chev 350?
It's at the top rear of engine, near the Distributor.
Where can you find the oil sending unit on a 98 Chevy 350?
It is right behind the distributor. It is HARD to see and to get to.
Where is the oil sending unit on 1998 350 Chevy truck?
Back of the engine, on the top next to the distributor.
Where is the oil sending unit on a 94 gmc sierra 350?
Usually right behind the distributor. in the back of the block.
9 Location of oil temperature sending unit for a 350 1985 corvette?
It is right behind the distributor. IT is HARD to get to.
Where is your oil sending unit on a 97 Chevy 350 vortec?
It is hard to see and to get to. But it's right behind the distributor.
How do you replace oil pressure sending unit on a 77 Chevy pickup 350 motor?
Unplug the electrical connector and slide the OIL SENDING UNIT SOCKET down over it and screw it out. It is a special socket. If you have the room you can screw it out with a pair of pliers.
Where is the oil sending unit on a 1985 ranger 2.8?
Where is the oil sending unit on a 2.8
