It's on the bottom of the engine, where the engine joins the transaxle. If memory serves correctly, simply remove the wires and the three bolts holding the starter in place and reverse that order to replace it. It's also important to note, that when doing any work with electrical parts on a car, always disconnect the negative battery terminal to avoid accidental grounding.
on ebay search for NEW STARTER CHEVY 4.3L S10 BLAZER, C SERIES TRUCK 99 00 01 02 03 04 & ASTRO VAN this gives you an image.
Low compression, weak spark or poor fuel delivery can make a vehicle more difficult to start in the cold.
disconnect the negative battery cable then the wires from the starter. Remove the mounting bolts and drop the starter down. Try this for Chev S10 problems. Buy the Chilton General Motors publication #28860. It covers S10s 1982-93 from detailing to engine rebuilds, including changing the starter.
Your vehicle has a starter solenoid which is piggy back on the starter.
The 02 Chevy S10 with a 4 cylinder or a 6 cylinder does not have a timing belt.
It is attached to the starter.
YES.
The starter solenoid is attached to the starter.
On the passenger side of the engine in the back.
Should be on top of the starter - follow the + battery cable
Backside, lower, passenger side of engine.
It is attached to the starter, just follow the positive battery cable from the battery, it will lead you to the starter solenoid.
Yes, two, there are located in the throttle body.
Behind the glove box
It is located in the throttle body.
the starter relay.
My 1989 chevy s10 doesn't accelerate quckly,why is this?