0
Just changed mine on v-6 3400 engine..the starter is on the passenger side of the engine. It's not an easy replacement but maybe I can save you some time. If your tacoma has skid plates, you will have to remove them for this procedure. Disconnect the battery before beginning and the the wiring harness from the starter. You will find it tucked up behind a holding bracket for the exhuast system. I removed the bracket to get at the 2 14mm bolts holding the starter in place. After the bolts are removed, go to the front of the truck and remove the bolt and bracket holding the starter harness to the block. This will give you enough room to extract the starter over the cross member, through the Power Steering lines and out. The new starter is just the reverse order. This seemed the easiest route after studying brake line removal to exit through the wheel-well, and it came out easy! Hopefully this helps, I know I wasted about 1/2 hr before removing the wiring harness bracket trying other possibilities. Good luck!
What else can I help you with?
You drive a 1996 Ford F150 4X4 it was running fine then you stopped for gas and it only made one click sound dash lights heater and headlights work but would not ingage?
Check the connections to the solenoid and to the starter.
How do you remove the starter on a 1998 Toyota 4Runner 4WD v6?
Here is a web site that I saw that will help you on removing and replacing the starter on a 1999 Toyota 4Runner: http://www.4crawler.com/4x4/CheapTricks/Starter.shtml
Where is the starter on a 1994 Nissan pickup?
The 1995 Nissan truck starter relay switch is located in the fuse box. The starter relay switch will be in the third column.
How do you change a serpentine belt on a 98 Dakota 4x4 with AC?
buy a belt, loosen the tensioner, replace belt
ATV won't start even when I jump it. Who can give suggestion?
I have a 1994 Polaris 4x4 with a battery that is about 9 months old and it won't start. I can hear the cylinoid clicking which is next to the battery. I have tried to jump the battery, but have no change in the results. The lights seem nice and bright so I don't think the battery is dead. I am leaning towards a starter problem, is this correct?
Which rear tire pulls on a 1996 tacoma 4x4?
They both do.
How do you bleed the hydraulic clutch on 1996 Toyota tacoma 4x4?
figured it out. thanks anyways.
Change starter on polaris ATV?
How do I replace the starter on my polaris 250 4x4 Model number is EC250PF00802151. How do I change the stater on a 99 polaris explorer 4x4
When do you change a timing belt on a 4X4 V6 Tacoma?
you almost nevet have to but 150000 i gess
Does a 97 Toyota tacoma 4x4 have front shocks or struts?
My 1997 3.4L 4x4 tacoma has struts but some may have springs My 1997 3.4L 4x4 tacoma has struts but some may have springs
How do you replace a front seat belt on a 1996 Toyota Tacoma 4x4 LX?
unbolt it from the floor you need a special tool
Oil capacity for 1999 Tacoma 4x4 6-cylinder?
5.5 quarts with oil/filter change.
Why 1996 Tacoma Lx 4x4 2.7L 4 cylinder cranks but won't start?
I say try changing out the crankshaft sensor.
What size motor does your 1996 4x4 4 cylinder tacoma have?
It is a 2.7 liter with 150 h.p. and 177 lb/ft of torque.
What is the engine oil capacity for a 1999 4 cylinder 4x4 Toyota tacoma?
5 quarts with filter change.
How do you remove the starter on a 1996 polaris explorer 300 4x4 ATV?
To remove the starter from a 1996 Polaris Explorer 300 4x4 ATV, first ensure the ignition is off and disconnect the battery to prevent any electrical issues. Remove the starter cover and disconnect the electrical connections from the starter. Then, unbolt the starter from its mounting brackets, making sure to keep track of the hardware. Finally, carefully pull the starter out from its housing.
Are all Toyota Tacoma's 2006 4X4?
No.
