answersLogoWhite

0

It probably needs shims added or subtracted to it. the wrong amount of shims will make it start hard

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Car makes fast ticking sound when key turned?

Battery dying - there isn't enough power left in the battery to turn the motor over during the starting process. Could also be the starter selenoid or the starter motor itself.


Why will the starter motor not start a Toyota Celica?

It depends if the starter is turning the engine over and its not starting the problem is not with the starter its with your ignition or fuel system most likely, If your start is making a whirring sound then its not making contact with the flywheel and you probably need a new starter


Do you have a bad solenoid switch on 1994 Mercury Sable you get a scraping sound when trying to crank it?

No, usually a scraping sound indicates the starter is dragging and needs to be replaced.


How can you tell the difference between relay solenoid or starter going bad in a Mercury Sable - Ford Taurus?

A starter will seldom "go bad", but when it does, you will definitely hear a "grinding" or "dragging" noise as it rotates (usually is slow to rotate). That condition is called "starter dragging", caused by worn bushings. When the bushings wear, the starter will drag against the armature inside the starter hull, causing the slow rotation and "dragging" or "grinding" sound. A single click when you try to start the vehicle is usually indicative of a faulty starter relay/solenoid. Or possibly just a loose cable. A rapid clicking sound is usually caused by a low battery. Could also be caused by a loose cale.


How can you tell the difference between relay solenoid or starter going bad in a Ford Windstar?

A starter will seldom "go bad", but when it does, you will definitely hear a "grinding" or "dragging" noise as it rotates (usually is slow to rotate). That condition is called "starter dragging", caused by worn bushings. When the bushings wear, the starter will drag against the armature inside the starter hull, causing the slow rotation and "dragging" or "grinding" sound. A single click when you try to start the vehicle is usually indicative of a faulty starter relay/solenoid. Or possibly just a loose cable. A rapid clicking sound is usually caused by a low battery. Could also be caused by a loose cale.


Would an ignition make a grind sound?

Yes, an ignition can make a grinding sound, especially if there is an issue with the starter motor, flywheel, or other components involved in the starting process. This noise may indicate that the starter gear is not properly engaging with the flywheel, or that there is a mechanical problem within the starter system. If you hear a grinding sound when attempting to start your vehicle, it's advisable to have it checked by a mechanic.


What sound does a starter make when its going out?

When a starter is going out, it often makes a clicking or grinding noise as the solenoid attempts to engage the starter motor but fails to do so. You may also hear a whirring sound if the motor spins without engaging the engine. In some cases, there may be a complete lack of sound if the starter is entirely dead. These sounds typically indicate that the starter is malfunctioning and may need to be replaced.


What will would stop a car not start but makes a clicking sound at the starter motor?

dead battery bad starter solenoid bad starter loose or corroded battery or starter cables


The motor wont even turn all you hear is the starter clicking sound right after the transmission was installed?

the motor is ether frose up, the starter is burnt up or ether it is not engageing


95 wrangler clicking sound when starting?

the starter cellanoid needs replaced.


93 rx7 will not start only makes a ticking sound?

Not enough power to starter motor.


Your BMW 3 series wont start has new battery but will start by jump starting makes no sound at all when turning the key any ideas?

fit a new starter motor ! simples ... next!