0
Probably have a defective power brake booster or the vacuum supply to the booster is restricted or leaking.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How does a foldaway brake pedal assembly work?
it does not work jam eti
What is wrong when your Brake lights on a 95 s-10 wont work when pedal pushed down and come on with headlights but the brake light still doesn't work?
theres a pressure switch just above brake pedal under the dash probably bad
Brake lights don't work when pressing the brake but turn with lights on my 87 Toyota supra?
May be stop light switch--usually located at the upper end of the brake pedal under dash
Your brake blinker and hazard lights dont work you changed the fuse in the fuse box you changed the brake light bulbs and you changed the the oob switch on the brake pedal what could it be?
Have an electrician check the wiring that goes to the brake lights in the trunk of the car.
Why does my dodge Dakota not shift into gear It will not come out of park And the brake lights arent working either. Could there be a connection?
There is what is called a brake sensor. This sensor has to engage to sent a signal to the transmission to release the pawl so that you can shift it. Replace the brake pedal sensor. It is usually on the top of the pedal arm upward under the dash. This will also cause the brake lights not to work. Good luck.
Can a brake pedal malfunction make your brake lights not work?
Usually that would be caused by a faulty brake light switch connected TO the brake pedal. If the brakes work the pedal is probably ok.
Stiff brake pedal and had the master cylinder abs replaced what could this be?
Check engine vacuum and power brake vacuum booster. If the brakes work but just require extra effort to stop, it's a brake boost problem.
Where is the sensor on the brake pedal I have no brake lights but the blinkers work and all fuses are good?
brake light switch is above the brake pedal under the dash
How does a foldaway brake pedal assembly work?
it does not work jam eti
Why don't the brake lights work but the flashers and running lights work if the bulbs and fuses are good?
Please check the Brake light switch....The brake light switch should be located near or on the brake pedal (up on the stem of the brake pedal)
What does a brake booster do?
a brake booster supplies power to the brake system. this takes the hard out of the brake pedal allowing brakes to work harder with less effort or pressure on pedal from the driver
What fuse controls the brake lighta on a 2000 dodge caravan. all lights work except no brake lights when pedal is pushed?
Check the brake light switch on the brake pedal
How do break lights work?
When you step on the brake pedal, you close a switch at the top of the arm that holds the pedal. That puts power to the brake lights
What is wrong when tail lights work on a 1995 Nissan pickup but the brake lights don't work?
Its the brake switch on the brake pedal. Its a plunger like switch, its usually the only thing on the brake pedal. Its pretty easy and cheap to change.
Brake light and cruise don't work on Chevy Avalanche?
Check the brake light switch on the brake pedal
What would cause the brake lights not to work on an 84 corvette when all of the running lights work?
BAD BRAKE LIGHT SWITCH AT TOP OF BRAKE PEDAL
What do you check when 2000 jeep wrangler brake lights do not work?
fuse, bulbs, switch on brake pedal.
