0
Why will a 1988 Jeep Cherokee not start after changing the injector o-rings?
Wiki User
∙ 12y ago
it probably has air in the fuel line i would turn the key to the run position then bleed the air out of the shrader valve located on the fuel rail ( it looks like a tire valve stem ) then try to start if that dosent work i have seen some Cherokees that you had to use starter fluid to get them to start then they act normal and start on their own after that.
Wiki User
∙ 12y ago
Wiki User
∙ 15y agoBecause the water pump has no relationship to starting. You are missing the spark or the gas. so start over
Add your answer:
Earn +20 pts
Truck will not start after changing lift pump on a 1999 Ram 2500 Cummins Truck will not start after several hours trying to bleed injector pump and only getting fuel out of 2 injectors?
If you are only getting fuel out of two lines, then the injection pump is probably bad.
Have fuel to your throttle body on your 1998 350 will not start but will fire and try to start on either help?
fuel injector
What jeans start with the letter c?
Chic, Calvin Klein, Cherokee
No fuel flow 1995 dodge cummins?
start by changing the fuels filter and make sure they are full of fuel.if the hold filter where empty on removal it's your priming pump that is falty then check the shut off selenoid on the injector pump it should have 12v power wiht ingnition key on
1992 camaro rs and it wont start it cranks but there is no gas in the fuel injector carb?
The most likely problem is the fuel pump. When you turn the car's accessories on you should hear the fuel pump turn on. It shouldn't be very loud. If you don't hear, it may be broken. You should check it. If it is in good shape check the carb/injector. If the carb/injector isn't damaged its a fuel line problem.
1994 jeep grand Cherokee wont start. If you let it sit for 30 sec to 5 min it will then start and run fine. I have no injector pulse or fuel pressure when its in no start mode.replaced fuel.no change.?
check the cranckshaft sensor and alarm system
What can you do if a 1995 GMC Sonoma does not start even though it has spark and fuel and air and the fuel injector orings were recently replaced and the battery is fully charged?
I have the same problem, I check theinject spark and fuel on my 1997 GMC sonmoa And it still won't start check all the fuse's, then i check the timing chain and replace, Still no luck . I am hope someone will help us both.
Why would a 1989 corvette have no injector pulse after changing the distributor module and the ECM Fuel pressure45psi. There is power to both injector wires with ignition on but no pulse.?
Try changing or checking the oil pressure switch next to distributor if it goes bad the engine will not fire or start. Motor (ECM) has to see at least 3 psi of oil pressure to start. And will also shut down if less than 3 psi.
Why wont 94 jeep grand Cherokee limited 5.2 wont start and no spark after changing transmission?
somebody broke or didn't connect the crank sensor
Why would a 89 Jeep Cherokee turn over but not start and changing the fuel filter didn't help but after changing the fuel pump it is slugish and backfires if it starts?
Have you checked the ignision timing. Check the firing order as well
1993 Mazda 626 is hard to start when its cold?
maybe weak battery or an injector component is defective ( the additional injector that gives extra fuel to start the car )
I have a Cold start problem with a 89 Camry 2.0 what can it be?
It can be battery, faulty coolant temperature sensor, faulty cold start injector, malfunctioning fuel system, injector leaking.
Who give the signal in the fifth injector to start 1992 Mercedes Benz 190e 2.3?
who give the signal in the 5th injector to start 1992 Mercedes Benz 190e 2.3
What would cause a Punto not to start?
Injector relay failed
Does a 2000 Dodge Ram 1500 have a cold start injector?
No.
Why would a 1995 Toyota Corolla have a rough idle?
I would start with changing the spark plugs, air filter, fuel filter. I would also try a couple of bottles of fuel injector cleaner, and dry gas.
Truck will not start after changing lift pump on a 1999 Ram 2500 Cummins Truck will not start after several hours trying to bleed injector pump and only getting fuel out of 2 injectors?
If you are only getting fuel out of two lines, then the injection pump is probably bad.
