0
Always go back to the basics, spark, fuel and compression. If you have all three, it will run. After putting in a cam position sensor you might want to verify that it's all set up properly and everything is connected. Often it's just something little that was missed, such as putting something in backward or not having the proper clearance set-up. What does the computer diagnostic code say? That will give you more information than can be provided like this.
What else can I help you with?
What does a crank shaft sensor do?
AnswerIt reads the position and/or speed of an engine as it is rotating. When crankshaft is turning, the sensor will provide a signal to the PCM. The PCM will then allow the engine to start by providing spark and fuel.
What could be wrong with your 91 Ford Ranger 23L if it won't start or get spark after you took out the coils and replaced them if all the wires look good?
bad crank shaft position sensor
Why would a geo prizm not have spark engine Turns but does not start replaced entire distributor 3 times already all components are located inside arent they Crankshaft position sensor?
the cam position sensor and ignition coil are inside the distributor. the crank position sensor is located on the bottom front of the engine, behind the belts on the left side.
Car worked check engine light was on codes say crank position sensor put new one it now car does not start left unconnected to battery and hour help?
Check the MAP sensor.
Your 96 camaro z28 won't start because of lack of spark?
96' z28 won't start because lack of spark. Could it be crankshaft position sensor? I just replaced distributor.
2002 Oldsmobile intrigue hard to start and stalls occasionally?
Its either your cam shaft position sensor or the crank sensor.
Why would a 2001 pontiac grand am turn over but not start?
Check the 2001 Grand Ams crank shaft position sensor first. If the sensor is bad then the engine will not get fire or start.
2001 jeep grand Cherokee won't start sometimes?
crank or cam shaft position sensor is sometime the issue.it will not fuel if it cannot find the position of the cam or crank
What does a crank shaft sensor do?
AnswerIt reads the position and/or speed of an engine as it is rotating. When crankshaft is turning, the sensor will provide a signal to the PCM. The PCM will then allow the engine to start by providing spark and fuel.
Would the crank shaft positioning sensor make the car want start?
car will not start if the crank shaft positing sensor is bad ..because it control the car spark plug firing..( no fire no start )
Would crankshaft positioning sensor cause no spark?
Yes. On some vehicles, the Crank Shaft Position sensor tells the computer that you are trying to start the vehicle. Without that signal, the ECM will not control the spark coil.
Why does my Mitsubishi L200 go into limp modewhen crank sensor has been replaced?
hi i have a 2004 mitsubishi l200 ediesel that wont start,turns over but not firing,been told its the crank shaft position sensor
Why won't your 92 Saturn start It starts when its cold but when it warms up it won't start. The engine cranks and cranks but won't start but i can push start it just fine?
it could possibly be a bad coil, crank shaft sensor, or cam shaft sensor.
What could be wrong with your 91 Ford Ranger 23L if it won't start or get spark after you took out the coils and replaced them if all the wires look good?
bad crank shaft position sensor
What are the many symptoms of a bad crank shaft position sensor?
No start, dies after driving a bit, won't start when hot after shut off are some of the symptoms. If you have a tach in the vehicle see if you have a consistant rpm reading also.
95 Lincoln Continental will not start?
I had the same problem and found out it was the crank shaft sensor!
Can the crank shaft sensor stop a car from starting?
Yes it can cause a no start condition.
