If it started previouslt then something disconnected (sensor etc) or timing is wrong
Check the ignition coil on the Cheyenne. If it is ok, check the timing. The timing chain could have slipped or broken causing the engine to not start.
if you haven't changed the timing belt recently, you might as well change the timing belt, water pump, and both idler pulley and timing belt tensioner. This way you can set the timing with the proper tools, that's probably what you'll have to do anyhow since the belt moved, hopefully it didn't damage any valves when you tried to start it and the belt was off timing.
If the timing is off by a few degrees the engine can start but will run rough. More than a few (depending on the engine) it will not start.
1. Make sure you are getting fuel to the carb... 2. If you are getting fuel and spark to you spark plugs and the plugs are wet, You more than likely have a timing problem.
No, timing is not adjustable. If timing is not correct a part has failed.
There could be many reasons why your Renault Kangoo will not start in the morning. These problems include battery failure, alternator issues and engine failure.
Typmy transponder chip has been damaged and my renault kangoo wont start now, how do i bypass the immobilizer so it will start
Kia, Ka (Ford), Kunga 4x4 (Ford), Kangoo MPV (Renault), Koleos 4x4 (Renault), Karmann Ghia (VW).
The key is faulty or the immobilizer will not accept the code. remove the battery for 30 mins to allow the system to reset.
To remove the ignition barrel on a Renault Kangoo, start by disconnecting the vehicle's battery to ensure safety. Next, remove the steering column covers to access the ignition switch. Insert the key and turn it to the accessory position, then locate and press the release pin or tab on the ignition barrel. Finally, gently pull the barrel out of the steering column.
2 possibles: 1:The engine was not timed correctly when the timing belt was replaced 2: An ignition lead left disconnected when the timing belt cover was replaced.
Chain is not timed correctly.
i changed timing belt and timing chine but my car know need good fix and not start very well,please help me
Double check the timing marks, maybe they are not lined up correctly after you changed the chain.
IF your previous timing chain broke, you most likely got your "cam to crank" timing out of whack. If it didn't break and it wouldn't start before you changed it, your first basic steps would be to make sure your engine is getting fuel, spark, and air.
That's an easy one! There is no timing belt. It is a timing chain. I have 130,000 miles and have not had any trouble. It will start making noise when it is time. Unlike timing belts which will break, timing chains wear out slowly.
can you start the engine of a 2005 renault megane with out key card