On the left side there is a spring steel clip. Push a fine screwdriver downwards between the light and the bumper at the same time pulling up on the left side. The steel clip will free itself allowing the unit to be lifted to the left and out - thus freeing the right hand locking lugs. Installation in the reverse - locate the right hand side locking lugs and push down on the left hand side to re-engage the spring steel clip. The bulbs are 12v 3w T-10 Wedge type.
how do you change the rear license plate light on a 1999 Buick Regal
How do you change the liscence plate light fuse
168
see:How_Change_VW_Polo_1999_Number_plate_light
Remove the cover using a tork bit.
To change the license plate light on a 1999 Lincoln Town Car, first, open the trunk and locate the license plate light assembly. Remove the screws or clips holding the light assembly in place, then gently pull it out. Disconnect the old bulb by twisting it counterclockwise, replace it with a new bulb, and reassemble the light assembly by reversing the removal steps. Finally, test the new bulb to ensure it works properly.
To fix or change a license plate light on a 1999 VW Beetle, first, open the trunk and locate the light assembly above the license plate. Remove the light cover by gently pressing on the tabs or screws, depending on the design. Replace the burnt-out bulb with a new one, ensuring it's the correct type, then reassemble the cover. Finally, test the light to ensure it is functioning properly.
Push in & turn the bulb a quarter & should pop out. Get the same no. bulb from an auto parts store.
The 1999 Mercury Sable license plate light and the right side brake light are on the same fuse. If the fuse was bad neither brake light would work. The problem probably is burnt out lightbulbs.
There is no change transmission lamp.
# 168 according to the 1999 Ford Mustang owners manual
You might have to remove the whole tailight bezel to replace that bulb, all the nuts for it are in the rear of the trunk compartment, the type of bulb is a 194 type.