answersLogoWhite

0

If it has a cable attached to the throtle linkage, release it by moving the locking tang and pulling the cable all the way to the rear. Then get inside and floor the accelerator and it will automatically adjust the cable.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you adjust the rear brake cable on a 2002 Chevy Cavalier?

At the "Y" in the cables at the rear of the car


How do you adjust the throttle valve cable on a 1992 cavalier?

To to adjust the throttle cable, first take off the air cleaner. Hold down the metal adjusting tab that is at the end of the cable.There is a sliding piece at the end of the cable, move it against the end. Let go of the adjusting tab then move the cable to the end.


How can I adjust the cable tension on my rear derailleur to improve shifting performance?

To adjust the cable tension on your rear derailleur for better shifting, turn the barrel adjuster on the derailleur or shifter to tighten or loosen the cable. Test the shifting after each small adjustment until it shifts smoothly and accurately between gears.


How to adjust the front derailleur on a bicycle?

To adjust the front derailleur on a bicycle, start by shifting the chain to the smallest chainring and loosen the cable tension. Then, adjust the height and angle of the derailleur so that it is parallel to the chainrings. Next, adjust the limit screws to ensure the chain shifts smoothly between chainrings. Finally, tighten the cable tension and test the shifting to make sure it is working properly.


What is the proper method for adjusting the rear derailleur cable tension?

To adjust the rear derailleur cable tension, start by shifting to the smallest rear cog. Then, loosen the cable anchor bolt and adjust the tension using the barrel adjuster until the chain shifts smoothly onto the cog. Finally, tighten the cable anchor bolt and test the shifting to ensure it is working properly.


How do you adjust the transmission cable on a 96 Oldsmobile ciera?

To adjust the transmission cable on a 1996 Oldsmobile Ciera, first, locate the cable at the throttle body. Ensure the vehicle is in park and the engine is off. Loosen the adjustment nut on the cable, then pull the cable housing until the slack is removed and the cable is taut, but not overly tight. Finally, retighten the adjustment nut and check the operation by moving the throttle.


How do you replace shift cable for 01 cavalier?

The shift cable on an 01 Chevy Cavalier is replaced by removing the retaining screws, removing the cable from the shifter, and pulling it from the vehicle. A new cable can then be locked into place and bolted down.


How do you adjust throttle cable on 94 olds ciera?

To adjust the throttle cable, first open the hood of the car and locate the cable. Then, adjust the screws on either side of the cable. Following that, tighten the cable so that it is taut and there is no slack, but it is not over tight.


Where is the speedometer cable located 98 Chevy cavalier?

There is no cable, the speedo is run electronically.


How do you adjust an F-250 shifter cable?

How do you adjust an F-250 shifter cable? 2000 model


How do you adjust the throttle cable on a 1996 ford escort?

Assuming there is nothing wrong with the timing belt, loosen the two clamp bolts, and move the cable in the middle adjustment position, if the transmission shifts too late or too early for you're liking, readjust the tension.


How do you adjust gear shifter on 2001 Ford Taurus?

You adjust the cable on top of the shifter module ( just below brake master cylinder) If you can't recognise this get someone else to sit in driver seat (with ignition on, but not running) and shift gears . You will see the cable moving on top of module. This bolt holding the cable can be adjusted VERY carefully.