coil kaput buy new
Whats happening is water from your washer jets is leaking and running down your airbox and somehow gettin into the coil pack/leads or plugs, causing the engine to misfire, engine management light will probaly be on the dash. It can be fixed by changin the coil pack but i would recoment tryin to change the spark plugs and leads 1st. This is a common fault with ford fiesta but it shouldn't happen with your year because they were realled 03/53 plates from then on the washer jets at a rubber seal on them to stop this from happning.
How do you change a coil pack on a 1997 cavalier
coil pack
how to change coil pack on 1998 plymouth neon
On the 2.0 L - SPI engine and the 2.0 L Zetec engine follow the spark plug wires from the spark plugs to the Coil Pack The 2.3 L engine has a Coil On Plug ( C.O.P. ) ignition system
IT DEPENDS ON THE ENGINE TYPE,ZETEC IS SIMPLE,PTE ALSO EASY,HCS NOT SO EASY AS COIL PACK IS AT THE BACK OF THE ENGINE AND IS BETTER DONE ONE AT A TIME BY FEELING AROUND AT THE BACK ITS EASIER WITH THE AIR FILTER OFF TOO.
To change a coil pack on an AU Falcon, first, ensure the engine is cool and disconnect the negative battery terminal for safety. Remove the engine cover, if applicable, to access the coil packs. Unplug the electrical connector from the coil pack, then unscrew the mounting bolts and carefully lift the coil pack out. Install the new coil pack by reversing the process, ensuring all connections are secure before reconnecting the battery.
To change the coil pack on a 1988 Oldsmobile 98 Regency, first ensure the engine is off and cool. Disconnect the negative battery cable and remove any components obstructing access to the coil pack, such as the air intake or engine cover. Unplug the electrical connector from the coil pack, then remove the mounting bolts and take out the old coil pack. Install the new coil pack by reversing these steps, ensuring all connections are secure before reconnecting the battery.
To change the coil pack on a 1998 Jaguar XK8, first, disconnect the negative battery terminal to ensure safety. Then, remove the engine cover to access the coil packs. Disconnect the electrical connectors from the faulty coil pack, unbolt it from its mounting, and replace it with the new coil pack. Finally, reconnect the electrical connectors, reattach the engine cover, and reconnect the battery.
The 2.8 V6 has a single coil, not a coil pack It is located behind the distributor and on top of the engine. Unplug the wire harness, un bolt and reverse procedure to change.
There is no distributor cap on a Pontiac sunfire, only a coil pack. coil pack is located on the back of the engine.