with a screwdriver
No, you do not have to .....
blown head gasket, cracked cylinder head, crack in the cylinder block
At the top of the cylinder head there is a bolt that you have to remove...if you look between the oil cooler pipes you will see it
The cylinder head torque specs for a Yamaha Radian is 35.61 Nm. You can also say the specs are 3.6 kgf-m and 26.3 ft.lbs.
To install a cylinder head on a Yamaha Blaster, first ensure the surface of the cylinder and the head are clean and free of debris. Position the head gasket on the cylinder, aligning it properly, then place the cylinder head on top. Secure the head using the appropriate bolts, tightening them in a crisscross pattern to the manufacturer’s specified torque settings. Finally, reattach any necessary components, such as the exhaust and intake, and check for proper alignment.
20 ft lbs
Yes as long as you change both heads.
20 ft lbs
Yes.
on top of the cylinder head just under the gas tank.
take your cylinder head off and change it.it is usually easyer to change the head
The head bolt torque specification for a Yamaha Breeze 350 typically ranges from 18 to 22 foot-pounds (24 to 30 Nm). It's essential to follow the correct torque sequence and specifications to ensure proper sealing and engine performance. Always refer to the service manual for your specific model year for the most accurate information.