Well, from what i understand of your question i think you are askign how to change front brake lights and corner lights. These are headlights and corner lights, brake lights are located at the rear of the car. Pop the hoos, you should see the wiring that hooks up to the lights. Unscrew the plastic"shield" that protects the bulb and change the bulb place it back in and screw the light back into place. (i recommend checkign to make sure the light bulb works before putting it back in the whole light) Good Luck.
you probably need to change your fuses you probably need to change your fuses
Front side lights
To change the side marker lights on this model, remove the screws of under cover that attaches to the bumper. It would be easiest to do if the vehicle was lifted up in some way.
The 1995 Pontiac Grand Am has reflectors on the sides that may look like side marker lights, but they are only reflectors. The tail lights and front parking lights are so positioned that they can be viewed from the sides, so separate side marker lights are unnecessary.
To change the reverse lights on a Pontiac Sunfire you need to locate it on the left side of the transaxle. Then, unplug the electric connector and remove the switch along with the socket.
Open the tail gate and look inside at the side of the bed where the lights are on the side of the bed and you will see 2 small phillp screews. Remove them and the light will come out.
Open your boot, on the left or right side depending on which side you need to change there will be a little panel behind where the lights are, unclip it, then there will be acircuit board unclip that and change the appropriate light if I remember it's the third one down, on the outer side, as they are like right next to each other. Or just take it to Halfords (Y) give you brake lights, fit them and check them for like a fiver.
yes the side lights can stay on
if you mean the running lights in the bumper. you can push on the one side of it lightly and it will depress, then slide it in the direction that it pushed in. the other side should pop out. then reverse the steps to reinstall it
Don't worry about breaking it, you will have to pop it out and replace the whole light. It usually run around $25 for a pair of lights.
near side lights not working
i would like to know how to remove the panels for the interior side lights to change the light bulbs