There are a few ways to clean a small engine carb. One is the simple way of applying the coke to the carb and spray a small amount of carb cleaner to the carb. Number two is to take the carb off and take it apart and buy a rebuild kit and rebuild the carb.
It's coded in the model #.
counterclockwise
You may have a hot wire grounding out somewhere
Your flywheel key might be sheared
sae30w
To swap an engine on a Murry riding mower, it is important to make sure that the new engine is the right match for the mower, by checking the model number. You also need to make sure that the bolt holes line up, so that it will fit safely. Remove the old engine, and then replace the new engine, tightening all the screws and bolts in the reverse order that you followed to remove the old engine.
Make a U shape with a paper clip then disconnect the wires at the switch and stick the clip into the wires and then tape it so the wire stays in
HOW TO CHANGE THE CUTTING HEIGHT To change the cutting height, raise or lower the lift lever as follows. 1. Move the lift lever forward to lower the mower housing and back to raise the mower housing. 2. When you ride on a sidewalk or road, move the lift lever to the highest position and move the blade rotation control to the DISENGAGE position.
Hard to answer without a deck size.
10w30 or 10w40 seem to work well.
20oz which is LESS than a quart of oil.
Murry Dickson's birth name is Murry Monroe Dickson.