DOT 3 and DOT 4 brake fluids are glycol based, making them very similar to antifreeze. It is best disposed of in the same manner as used antifreeze and sent for recycling.
Coolant is used to keep an engine in a vehicle at a temperature safe for operation. If no coolant is in the reservoir, an engine will not start.
To wash out the coolant system in a Peugeot 307, first ensure the engine is cool and then drain the old coolant from the radiator and engine block. Refill the system with a mixture of water and a cooling system flush product, run the engine for about 10-15 minutes to circulate the flush, and then drain it again. Finally, refill the system with the appropriate coolant mixture and check for leaks. Always dispose of old coolant properly, as it is toxic.
Green coolantGreen coolant
To drain coolant from a RZR 800 motor, first ensure the engine is cool and the vehicle is on a level surface. Locate the coolant drain plug, typically found on the engine block or water pump, and place a container underneath it to catch the coolant. Remove the drain plug carefully to allow the coolant to flow out, and be sure to dispose of the coolant properly. After draining, replace the drain plug securely before refilling with fresh coolant.
Ethylene Glycol.
You dont Take it to a qualified mechanic for a flush and they will dispose of the old coolant You dont Take it to a qualified mechanic for a flush and they will dispose of the old coolant
Engine coolant in an Alero is used in the radiator. A diagram and instructions for how to properly use the coolant can be found on the package instructions. An owner manual will also assist in proper use of coolant.
Use only VW "pink" coolant!!! Rempve the coolant tank cap on a cold engine. There is a drain petcock on the driver's side of the 1.8T engined radiator. There is also an engine block drain on the driver's side of the engine near the oil filter flange. Drain the fluid and dispose of properly. Refill with genuine "pink" VW coolant after securing thr drains - DO NOT OVERTIGHTEN! Start engine, attain operating temperature, check for leaks.
Bring it to a recycling center
extende life coolant
Your engine coolant temperature gauge has a sensor ( there is also a engine coolant temperature sensor that is used for the computer / PCM )
To add coolant to a SLK 230, first make sure the engine is cool and then locate the coolant reservoir, which is typically near the front of the engine bay. Open the reservoir cap carefully to avoid any pressure release, and check the coolant level; if it's low, add a mixture of the appropriate coolant and distilled water as recommended in your owner’s manual. After filling, securely replace the cap and check for any leaks before starting the engine. Always dispose of any spilled coolant properly, as it can be hazardous to pets and the environment.