My toro weed trimmer motor revers up super high when choke is taken off, when hit the gas to trim weeds goes even higher on rpms. Have checked oil to gas mix several time thinking was wrong, good there. How do I adjust the idle lower?
Your Ryobi weed eater string may not be coming out due to a tangled or jammed string, a worn-out spool, or a faulty trimmer head. To fix it, try removing the spool and untangling the string, replacing the spool if necessary, or checking and replacing the trimmer head if it's damaged.
A line trimmer, also known as a string trimmer, is used to trim grass or weeds. The piece of equipment also goes by the name of a weed eater, or weed whacker.
no
You remove the bottom cover off the weed trimmer, and remove the tangled old wire. Insert the new wire into the side of the trimmer and wrap it around the black spindle.
40:1 owner's manual for a homelite st 185 trimmer says 32:1
weed-ate, or cut with the string trimmer
Nylon
what is the gas/oil mix for the 24cc weed trimmer by craftsman
The Weed Eater Electric Trimmer is one of the easiest to use
I solved my own problem,my weed trimmer has a on and off switch the wire in the switch had a bare place that was shorting out, by lifting the trimmer I was putting pressure one the bad connection.
weed-whacker- for trimming ground plants/weeds trimmer- for trimming bushes or shrubbery
To replace the weed trimmer line on a string trimmer, follow these steps: Turn off the trimmer and disconnect the power source. Remove the spool housing by pressing the tabs or unscrewing the cap. Take out the old line and cut a new piece to the appropriate length. Insert the new line into the trimmer head following the arrows for the correct direction. Reassemble the spool housing and test the trimmer.