There is a little lever on the bottom of the seat. Pull that out and close the seat so that the backrest is touching the bottom of the seat. Then pull out the handle on the side of the back of the seat. The seat will then unlock from the hinges.
To remove the back seat from a 2008 Buick Lucerne, first, locate the seat release mechanism, typically found at the base of the seat or near the rear seat bottom. Pull the release levers or push the buttons to unlock the seat. Next, lift the front of the seat bottom to detach it from the clips, then pull it out. For the backrest, locate any bolts or clips securing it, remove them, and then tilt and lift the backrest out of the vehicle.
To remove the back seat in a 1998 Ford Escort ZX2, start by locating the seat release mechanism, which is typically found at the base of the seat. Pull the release levers or push the clips to detach the bottom cushion. For the backrest, there may be bolts or clips at the bottom or back that you need to remove. Once unfastened, you can lift the backrest out of the car.
facing the backrest of the seat it is on
To remove the rear seat from a 1998 Hyundai Excel, first, locate the seat release levers or bolts, which are typically found at the base of the seat cushion or along the backrest. Pull or unbolt these fasteners to release the seat cushion, then lift it out. For the seat back, check for any bolts or clips securing it to the vehicle, remove them, and then carefully pull the backrest upward to detach it. Always refer to your vehicle's manual for specific instructions and safety precautions.
Under the back seat. It will lift up and forward on a pivot. Tools are mounted to floor under the seat. Just look for the loop in the crevice between the backrest and the bottom seat and give it a pull.
To remove the back of the Graco 3-in-1 car seat for booster use, first, ensure the seat is uninstalled from the vehicle. Locate the red release lever or button at the back of the car seat, and press or pull it to detach the backrest from the base. Once separated, store the backrest safely, and use the seat as a booster by securing it with the vehicle's seat belt according to the manufacturer's instructions. Always refer to the user manual for specific guidance related to your model.
if you are talking about the keypad entry module it is behind the rear seat on the drivers side pull the backrest off the seat then pull away the carpet its right there (the code is also on the module) if you are talking about the keypad entry module it is behind the rear seat on the drivers side pull the backrest off the seat then pull away the carpet its right there (the code is also on the module)
You must use your key to open the storage compartment on the backrest, then remove the screws found inside. Once removed, lift the seat up and pull back at the same time.
Pull up on pull tab at center back of seat and fold forward. This releases seat back to fold down. That's true, but to go all of the way down, you have to take the headrests out of the backrest and install it in the back end of the seat once it has been pulled forward. The pull tab for folding the rear seat on my 2-door is located on the seat portion on the passenger side of the rear seat. Sometimes the latch, which the pull tab releases, gets stuck. It may take someone rocking back and forth in the back seat while the other person pulls on the pull tab to release a stuck latch. == == == == == ==
pull the straps on the ceiling of the trunk. they're black.
To remove the back seat of a Volvo C70, first, locate and remove any screws or bolts securing the seat base to the floor; these may be hidden under plastic covers. Next, lift the front of the seat base to detach it from its mounting points, then pull it out. For the backrest, locate the release mechanisms or bolts at the base and carefully pull it upward to remove it. Ensure you check for any connectors for seat belts or electronics before fully detaching the seat.