0
First,turn ignition key to start.Set Park brakes.With foot on brakes shift to "D" or 3 or 2.Remove "U" clip from shift knob (pocket knife works best).Pull knob off stick.Open console lid and remove the 2 small screws at the bottom of the console.Disconnect light and cigarette lighter wires.Lift off console.Reverse order to re-install.
Note: U-clip comes out towards dash.
What else can I help you with?
How do remove the center console on a 1993 Oldsmobile cutlass supreme?
lift up the center plate on the console were your gear select is after you remove your shift lever and all the lever pieces and there you can remove the top of the console and the bottom has 4 bolts 10mm remove those and you shift your car all the way down to first or low gear and lift it up un plug the harness and there you go
How do you repair the console shift indicator light of a 2000 Olds Intrigue?
Just remove the console and you can get to it.
How do you get under shift console in 2007 chrysler sebring to press transmission rance sensor to get out of park?
Remove the bolts holding the console down and remove.
How do you remove the console shift knob on an AT 1993 Olds Achieva?
To remove the console shift knob on the AT 1993 Olds Achieva, first pry the cover from the top of the shift knob. Then, access the single screw inside the cover of the shift knob and turn it counter-clockwise to release the knob.
How do you change a shift console bulb on a 2002 Jeep Liberty?
Begin by removing the 2002 Jeep Liberty shift console retaining bolts. Lift the shift console up and the light bulb will be visible. Take hold of the light bulb, push in and turn at the same time to remove it. Reverse the process to install your new shift console light bulb.
Your 2001 Civic console shift automatic is stuck in park is there a way to get it out?
if you dont have a slot on console you have to pop remove the center console plate on top there a release under there
How do you remove a 2001 Hyundai Elantra center console?
Pry out the gear selector trim with a screwdriver and lift it out.Open the console lid and remove the screws on the bottom.Remove the screws on both sides of the console.Lift the console up and over the shift lever.Disconnect any electrical connections and remove the console from vehicle.
How do you replace a manual shifter in a 1995 cavalier Z-24?
* Remove the shift lever knob,console and shift boot * Disconnect the shift and select cables from the shift control assembly * Remove the large shift cable retainer plate and detach the cables from their bracket on the shift control assembly base * Remove the shift control assembly retaining nuts and remove the shift control assembly
How do you change light bulb in the gear shift of 06 Pontiac grand prix?
Front Floor Console Replacement Removal Procedure 1. Apply the park brake. 2. Remove the floor console bolts from the sides of the console. Adjust the front seats as required. 3. Shift the transaxle to 2. 4. Remove the screw from the shift handle. Remove the shift handle. 5. Pull the floor console rearward slightly. Disconnect the electrical connector at the front of the floor console. 6. Remove the floor console. 7. Remove the wiring harness. 8. Remove the HUD switch, if equipped. 9. Remove the traction control switch. 10. Remove the accessory power receptacles. 11. Remove the armrest and the hinge. Installation Procedure 1. Install the armrest and the hinge. 2. Install the accessory power receptacles. 3. Install the traction control switch. 4. Install the HUD switch, if equipped. 5. Install the wiring harness. 6. Position the floor console to the vehicle. 7. Connect the electrical connector at the front of the floor console. Slide the floor console toward the front of the car. 8. Install the shift handle. Install the shift handle screw. 9. Shift the transaxle to P. Notice: Refer to Fastener Notice. 10. Install the floor console bolts. Adjust the front seats as required. Tighten the bolts to 10 N.m (89 lb in). 11. Release the park brake.
How do you remove a gear shift cable on a ford escort?
Escort doesn't have a gear shift cable. It has a gear shift rod. To remove it: Remove the shift control rod nut and bolt Take off the shift knob. Remove the console. Remove the shift boot. Pry out the shifter spring. Lift the shift ever out of the housing. Take the nuts that hold the shift housing on the end of the extension bar. Take the extension bar from the transaxle, lower the shift housiing and take the shift control rod from the transmission.
How to replace a gear shift console bulb in 2001 Cavalier?
Remove the cover of the console..around 4 screw ..then lift the cover ,you can see the small bulb on it..
How do you replace the gear shift indicator light bulbs a 1997 Subaru Outback?
You have to remove the console cover. This starts with two screws in the console storage tray.
