Just remove the console and you can get to it.
To remove the center console on a 2000 Oldsmobile Intrigue, start by disconnecting the negative battery cable for safety. Next, remove any screws or fasteners securing the console, which are typically located in the armrest compartment and around the base. Carefully pry up the center console, starting from the rear and working your way forward, ensuring to disconnect any wiring harnesses for components like the power outlet or shift indicator. Once all connections are free, lift the console out of the vehicle.
lift up the center plate on the console were your gear select is after you remove your shift lever and all the lever pieces and there you can remove the top of the console and the bottom has 4 bolts 10mm remove those and you shift your car all the way down to first or low gear and lift it up un plug the harness and there you go
To replace the shift cable on a 1998 Oldsmobile Silhouette, first, disconnect the negative battery terminal for safety. Then, remove the center console to access the shift cable, detaching it from the shifter and the transmission linkage. Install the new shift cable by reversing the removal steps, ensuring it is properly secured and connected. Finally, reassemble the center console and reconnect the battery.
Depends. Usually low or dirty fluid. Get it checked by a professional.
To replace the auto trans shift cable on a 1998 Oldsmobile Silhouette, first, ensure the vehicle is parked on a level surface and the ignition is off. Remove the center console to access the shift cable connection at the gear shifter and disconnect it. Next, follow the cable to the transmission, detach it from the transmission lever, and remove any retaining clips. Install the new cable by reversing the steps, ensuring all connections are secure before reassembling the console.
STEP 1: Remove the console topOpen the console arm-rest and remove the two bolts near the latch.Lift the console from the now un-bolted end and carefully pry up from opposite end (there are 4-6 tensioning-pins holding the remainder of console top.BE CAREFUL - you have a plug in the console top for the traction control.Lift up the console top and adjust it out of the way.STEP 2: Remove the shifter position indicatorIf you're REALLY god at working in small spaces, you MIGHT be able to remove the bulb socket from the shift indicator without removing it, but realize you have to turn/twist the bulb socket about 90 degrees and then pull down.The bulb is on the driver's side of the shift indicator. Remove the indicator by removing four bolts and lifting up slightly to gain access. Twist the bulb out of the indicator module, replace bulb, and return bulb socket into the shift indicator.Turn ignition key on to assure the new bulb is working properly.STEP 3: Reassemble the consolePlace the shift indicator module back in place and put in the four bolts.Set the console top tension-pins into place and press back down working from dash-end back to console glovebox compartment.Insert the two console-top bolts back in at latch area of console glovebox.DONE!
The 2000 Oldsmobile Alero shift solenoid is located on the top of the transmission. The shift solenoid can be access by removing the inside shifter console.
there should be a u shaped clip in the front of the knob, almost like a staple. pry that out with a screwdriver and the knob should pull off.
To remove the shift knob on the 1999 Olds Intrigue look for the pin that is holding the knob in place. Remove the pin and pull up on the knob, replace kob and pin.
Remove the bolts holding the console down and remove.
You would have to replace the whole thing, it only about $30 its a locking pin that looks like a staple pull it out and it should come off....... easy do it your self