It's not advisable to mess around with an airbag as it contains a BOMB like explosion to deply the airbag. It should be held in by a few screws Be warned dont face directly at it incase of deploy
Normally located to the right of the steering wheel. It is a numeric keypad.
There is a TDC sensor on the front of the gearbox bell housing of most 306 Diesel models (up to MY '99 I believe) Neil
The thermostat for the cooling system can be found on the front of the engine. You can follow the bottom radiator hose to the thermostat housing. The thermostat will be within the thermostat housing.
the location of the horn on the pug 307 is located in the nearside inner wheel arch, To get access you have to remove the wheel and the plastics in the area and once done there you have it right in front of your eyes. Hope this helps...........Also maybe worthwhile thinking of the comms module on the back of the airbag..I hear these can be problematic too.
Punch a hole in the middle of the pug and pry hard it can take a lot.
How to remove a glow pug wiring harness from a 6.0
Take off the engine cover and remove the HT leads. You will then see the sparkplugs.
Pug
you dont
have lost code for my pug and i dont know how2 disarm it can u help Think you have to remove drivers seat to get at wiring Think you should sell the car on Ebay, and attach a rear spoiler To unlock the immobilizer there is a button with lines on it near the ignition switch, as you turn the ignition press this button, it will turn off the immobilizer.
A pug. A pekinese, not quite sure of the spelling.
pug diesel turbo r good for 150,,,170 thousand miles... The above answer is mad I bought my partner a pug 306 D its done 130,000 miles I dont know for sure if its ever been replaced but it was in serious danger of snapping when I checked it. A manual for this car will state a chgange every 72000 miles max but recommend every 36,000miles. Using the above advice im sorry is dangerous. I hope this helps any doubt refer to the Haynes manual.