0
What else can I help you with?
How do you change the valve gasket on a 1984 Nissan z24?
do you mean valve cover gasket? remove the air cleaner. remove the bolts from the valve cover, remove old gasket, clean valve cover with parts cleaner or degreaser (rinse after) put new gasket, retighten screws alternating till snug but not far to tight. make sure you have the correct gasket, alot of places dont stock them and will need to order them.
How do you remove the head and replace a head gasket on an 1984 Mazda B2000?
take it to a pro
How do you replace the head gasket located on a 1984 Buick Regal?
Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
Were do you add oil in the 1984 Monte Carlo?
look for a oil cap that you take off on the valve cover.
Why does 1984 ford 300 6 cylinder create vacum in valve cover?
The engine should have a crankcase breather tube connected between the valve cover and the air cleaner. With the crankcase breather removed and a non-vented cap installed on the valve cover in its place, the PCV would create the vacuum you have.
How do you replace a head gasket on a 1984 Chevy cavalier?
THEIR IS ALOT INVOLVED IN PREFORMING THIS JOB CALLME 724 575-2821 JASON...............
How much does it cost to replace a 1984 Camaro Z28 350 cubic inch engine blown head gasket?
I'd do it for about $350 - both sides.
How do you install a cam on a 1984 Mazda b2000?
This should be covered in most manuals. The valve cover has to come off, then you will vave to remove the rockers and bridges which cover the camshaft. The bridges come off by removing the head bolts. I think the head gasket should be able to be reused if you do not move the cyl. head. You may want to replace the cam bearings while you have the cam out. You may be able to get the sprocket off without removing the water pump and timing cover. If not, you will have to remove the fan shroud, fan, water pump and timing cover. I've only performed this procedure with the engine on the stand. If you run into any problems you can email me at ImDrunkOrUrCute@sbcglobal.net. Hope this helps. ~Christopher
What is the valve clearance on a 1984 Honda XR500R?
intake .004" exhaust .005" is the correct valve clearence for a 1984 xr500r.
What are the release dates for Cover Story - 1984?
Cover Story - 1984 was released on: USA: 2 March 1984
If your 1984 Corolla is making noises like there are spoons strapped underneath the valve cover what is wrong?
SOUNDS LIKE THERES NO OIL REACHING THE UPPER PARTS OF YOUR ENGINE.
What are the release dates for Cover Story - 1984 1984-03-02?
Cover Story - 1984 1984-03-02 was released on: USA: 2 March 1984
