0
losen the plastic inner wiings at the front then you can see the bolts at the side10mm heads there are two bolts at the front going upwards in slots loosen these off a few turns.Behind the washer bottleis a10mm bolt in the bar that holds it remove this and the two at side and it will pull off forwards
What else can I help you with?
How do you change the front lights on a peugeot 106?
you haft to remove the bumper first to get to the bolts holding in the lights
Do you have to remove the bumper to change a peugeot 106 headlight?
Yes
Are all peugeot 106 bumper mounts the same?
Yes
How would you install front fog lights on a peugeot 106 independence 2001?
To install front fog lights on a Peugeot 106 Independence 2001, begin by purchasing a compatible fog light kit. Remove the front bumper to access the fog light housing areas, typically located in the lower grille sections. Mount the fog lights securely, then connect the wiring harness to the vehicle's electrical system, ensuring a proper ground connection. Finally, reattach the bumper and test the fog lights to ensure they function correctly.
Where is the location of the power steering pump on a peugeot 106 1.1 zest 2?
hi i have a pug 106 independance an the power steering pump is located just behind the front bumper on the passengers side
How do you remove a Peugeot 106 front wing?
To remove a front wing from a Peugeot 106, first, ensure the vehicle is securely supported and the battery is disconnected. Remove any trim pieces and bolts securing the wing to the body, which may include screws along the top edge, bolts inside the wheel arch, and possibly under the front bumper. Carefully pull the wing away from the body, taking care not to damage any adjacent components. Finally, if applicable, disconnect any electrical connections for indicators or side lights before fully removing the wing.
How do you replace front shock absorbers on a Peugeot GTI?
How do you change a shock on a Peugeot 106 gti
Where is the washer pump on a 106 Peugeot?
Its In the washer bottle which is located inside the front wing. remove wheel and wheelarch liner to gain access to it.
How do you remove a cylinder head from a peugeot 106?
with a bar of soap
How do you remove the front wishbone on a Peugeot 106?
To remove the front wishbone on a Peugeot 106, first, ensure the vehicle is safely raised and supported. Remove the wheel, then disconnect the ball joint from the hub by removing the retaining nut and using a ball joint separator if necessary. Next, unbolt the wishbone from the chassis and any additional brackets or components attached to it. Finally, carefully extract the wishbone from its mounting points.
How do you remove door handle Peugeot 106 Tried always but cant do it aaghhh?
on my r reg 106 i drilled out the 2 rivits
What is the correct tire pressure for a Peugeot 106 Independence?
32 PSI front and rear, whatever the load.
