0
Yes, leaving stitches in for too long can lead to complications such as infection, scarring, or delayed healing. Stitches are typically designed to be removed after a specific period, depending on the location and type of wound. If they are not removed, they may become embedded in the skin or cause irritation. It's essential to follow your healthcare provider's advice regarding stitch removal to ensure proper healing.
What else can I help you with?
Are pools dangerous?
Swimming Pools are dangerous because if you hit your head on the side of the pool and get knocked out, you will go into the water unconcious and drown.
Why are pools dangerous?
Swimming Pools are dangerous because if you hit your head on the side of the pool and get knocked out, you will go into the water unconcious and drown.
Where is the knock sensor located on a 1995 Toyota 4runner?
its located under the head on the drivers side you can buy the wire separate 25 bucks the head has to be removed
I hit my head on the side of the bed and now i got a huge knot on the side of my head is this dangerous should i be worried or am just being totally paranoid?
if it still hurt and you doesn't feel good for 1 week. try to consult a doctor.
Do steroids work?
Yes they do work, and yes they are dangerous and have many negative side effects.Yes they do work, and yes they are dangerous and have many negative side effects.Yes they do work, and yes they are dangerous and have many negative side effects.Yes they do work, and yes they are dangerous and have many negative side effects.Yes they do work, and yes they are dangerous and have many negative side effects.Yes they do work, and yes they are dangerous and have many negative side effects.
Do you have to remove engine to do head gasket citroen 19 diesel?
The short answer is no! Although from memory, you will have to support the engine on the timing belt side (front of the engine) as the engine mounting on that side needs to be removed.
How much is a 1997 quarter worth if it is only stamped on the head side?
The coin needs to be seen and weighed, take it to a coin dealer, likely the reverse has been removed by some process out side the Mint.
How can you measure knit fabric?
You use a gauge or tape measure and count how many stitches per inch.It may not be a whole number, though.Example:You may have 4 1/2 stitches per inch. If you wanted to know how many stitches you needed to cast on for the desired measurement, you would multiply the number of stitches per inch by the number of inches you needed.Example II:If you neede a garment to finish at 40 inches, you would be making two pieces, with each being 20 inches.Example III:So if you had 4 1/2 inches per stitc, you would multiply this by 20 inches and you would need to cast on 90 stitches, adding 2 stitches for sewing so a total of 92 stitches for each side. This would be a total of 92 stitches per side.
How can I crochet a half circle?
To crochet a half circle, start by creating a chain of the desired length. Then, work in increasing stitches on one side and decreasing stitches on the other side to form the curved shape. Continue this pattern until you reach the desired size of the half circle.
Trying to replace head gasket on 2001 Sebring 2.7l am down to bare head 3 smaller and 8 larger bolts removed 2 altern bolts removed manifold disconnect from pipe left side still held down?
If you have all of the bolts out, you just need to pry up gently.
I have painful knot on the right side of my head near my temple It actually hurts and I have a clicking type noise in my head that seems to come from about the same place Is this dangerous?
That might be a migraine, but you should still see a doctor if you are unsure.
How do you change a camshaft sensor on a dodge neon?
on the right side of the head there are four screws/bolts that need to be removed . then disconnect the sensor from the harness installation is reverse of removal
