0
What else can I help you with?
How do you hook -up a gas hot water heater?
residential? commercial? new ? replacement? if its a new water heater in a new home then the easiest way is to buy copper flex's and a gas flex and make sure you have low pressure gas at your gas stop like around 10 to 14" water column. Make sure you have a cold shut off on your cold water line before you hook up to the water heater and in some states they require a expansion tank. One good rule of thumb is if you have a check valve somewhere around your water meter or if on a well by your pressure tank then its a good idea to put a expansion tank.
How do you connect flex pipe to a copper tubing?
You use a compression fitting or something like a Sharkbite.
How do you use fluidity in a sentence?
The word "flex" means to bend something that is pliant or flexible. Or it can also be used to refer to the contraction of a muscle as in, "The body builder would flex his arm and show how big his bicep muscle is." Other examples of the uses of the word flex: "As the strong wind blew, the young trees would flex from side to side." "When the diver jumped to begin his dive, the diving board would flex under his weight and allow him to spring off the board into the swan dive." "I have arthritis pain in my knee each time I flex the joint." "My stubborn co-worker would not flex his plan to fit the needs of the other department."
Can you connect PEX to a water heater?
No. Not directly. It needs to be 18 inches away... in length, not distance according to the UPC. An 18 inch water heater flex would work or 18 inches of copper tube with a pex adapter on the end will work.
I had a water heater installed and the guy used a galvanized elbow at the top of the heater to connect the copper flex hoses is this proper?
No its not.. this is a cheap way of doing it... You'll need to watch the galvanized pipe as it'll begin to rust and eventually leak due to the heat... The best is to use copper...
What causes ac flex ducts to fill with water?
AC flex ducts can fill with water due to condensation forming on the duct surface from temperature differences between the cold air inside the duct and the warmer air outside. Poor installation, insulation gaps, or clogs in the ductwork can exacerbate condensation issues. Additionally, high humidity levels or improper drainage can contribute to water accumulation in the ducts.
Should kids have flex time?
Depends on how muscular they are.
What flex plate should be used on casting?
The flex plate should be chosen based on the engine and transmission combination you are using. It should match the bolt pattern and size of the crankshaft and torque converter. It's best to consult the specifications of your specific engine and transmission to determine the correct flex plate to use.
Which hockey stick flex is stiffer mid or regular?
The regular flex is a stiffer flex than the mid flex. A regular flex is comparable to an 85 flex. The mid flex is closer to a 75 flex.
If your elbow clicks every time you flex it what should you do?
Find a doctor.
Why is there a flex on a plug?
Because after the plug is plugged in, there has to be some way of conducting the power away. That is achieved by cable or flex, using copper wires that are insulated for safety and other reasons.
What are the best practices for installing a sink flex hose in a kitchen?
To install a sink flex hose in a kitchen, follow these best practices: Turn off the water supply. Remove the old hose. Attach the new flex hose to the faucet and the water supply valve. Tighten the connections securely. Turn on the water supply and check for leaks. Adjust the hose as needed for proper positioning.
