answersLogoWhite

0

Raise car securely, remove wheel, brake calipher and brake rotor. Remove the bolts on the inner part of the axle where is bolts to the transaxle. Place jack under lower control arm and then separate lower arm from spindle by removing the nut on the lower ball joint. Remove the axle nut and pull the spindle out from the axle while pushing the axle thru it. Reverse procedure. I hope this helps you. Mark

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you replace a passenger side cv axle for a 1992 ford tempo?

To replace the passenger side CV axle on a 1992 Ford Tempo, first, safely lift the front of the vehicle and support it with jack stands. Remove the wheel, then disconnect the lower control arm and any necessary components to access the axle. Remove the axle nut and pull the axle out of the hub, then slide it out of the transmission. Install the new axle by reversing the process, ensuring all fasteners are properly torqued.


How do you replace passenger side drive axle 2003 Mazda 6?

To replace the passenger side drive axle on a 2003 Mazda 6, start by safely lifting the vehicle and removing the front wheel on the passenger side. Disconnect the lower ball joint and any necessary components to gain access to the axle. Remove the axle nut and pull the axle out of the hub, then slide the inner end out of the transmission or differential. Install the new axle by reversing the steps, ensuring all components are securely reattached and the axle nut is properly torqued.


How do you replace the alternator on a 1995 Oldsmobile Cutlass Supreme?

You have to remove the passenger side wheel, and inner fenders, then the drive axle and heat shield, then you can get at it. From underneath.....sorry.


How do you replace right cv axle 2002 ford escape?

how to remove, or replace front right axle escape 2004


How do you replace afront passenger side drive axle on a 2001 s-10?

this is a 4x4


99 Toyota 4runner replace rear axle bearings?

Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.


How do you replace the passenger side CV axle on a 1992 Nissan Stanza XE?

Easy fix!


Remove replace half axle 1986 Cadillac?

buy a Buick


How do you remove a broken boot on the left front axle of a '94 Plymoth Acclaim?

It's better to replace axle


How do i replace the front left axle to 2002 mercury villager?

Jack the car up, loosen the bolts and remove the wheel. The next thing is to loosen the nuts joining the axle to the stath then remove the axle.


Is the axle on a 1991 tracker floating How do you remove it to replace the outer seal?

The axle on a 1991 Suzuki Tracker is a semi-floating design, meaning it has a shaft that is supported at both ends but relies on the wheel hub for additional support. To remove the axle to replace the outer seal, first, remove the wheel and brake components, then disconnect the axle from the wheel hub and the differential. Finally, pull the axle out of the housing, taking care to replace the outer seal before reassembling everything.


Ineed to replace the balljoins on a f350 4x4 and i need to now how to pull the front axle out.?

do you have it all apart? The spindle removed from the nuckle? on the driver's side pull harder. The use of a prybar or large screwdriver might help. On the passenger side remove one of the metal clamps on the rubber boot in the middle if the axle an replace it when you are done.