If that is a cast iron engine its 5 horse, look up Smiths small engines in Google that's were I get all my old parts.
AnswerI used to have this really old snapper rider that i had to reguild the engine on and I found parts through the local lawn mower shops and through online lawn mower parts sites. Hope this helps you.Call the Briggs and Stratton tech support line on www.briggsandstratton.com. You might even end up talking to me! I'm looking through a parts & repair manual for the model 14 as I type this...
yes, i use them on my 17-1/2 hp briggs,
Yes, most all of the Briggs single cylinder engines are exchangable. You just need to be concerned to make sure that you don't under power your mower. In your case that is not a problem.
The torque sequence for a single cylinder Briggs and Stratton engine horizontal shaft head is increments of 2's for hp and 1's for head bolts. That makes 11 head bolts for an 18 hp.
Cylinder Head Torque is 190 inch pounds or 22.0nm
0.030 is the gap for briggs and stratton 4.5 hp mower
You can get that info on the Briggs and Stratton website. Just go to: http://www.ereplacementparts.com/briggs-and-stratton-parts-c-16758.html?gclid=CPCZj4vGr58CFZdM5Qodp3bDsA and enter your engine model number.
Where is the location of the idle screw on the Briggs and Stratton 6.0 engine mulcher mower?
Kohler for sure
The 15.5 Briggs does not have an oil filter.
Briggs & Stratton part # 491056 NAPA filter # 1348
If the first two digits of the engine's model number are the same, the answer is yes.
How do I change points to electronic ignition on a 5 hp briggs & stratton small engine?