0
What else can I help you with?
What year did electronic ignition start on harley?
1978
What is the spark plug gap for a 1986 fxrt harley Davidson with points ignition?
point gap for a 1986 Harley flt class
Harley Davidson 1988 shovel head ignition diagram and wiring repair and where can i find specs?
Harley stopped production on the Shovelhead in 1984
How do you replace a ignition cylinder on a 2004 Harley Sportster?
To replace the ignition cylinder on a 2004 Harley Sportster, first disconnect the battery to ensure safety. Remove the ignition switch cover and unscrew the ignition cylinder from the switch assembly using the appropriate tool. Insert the new ignition cylinder into the switch, secure it with screws, and reattach the ignition switch cover. Finally, reconnect the battery and test the new ignition cylinder to ensure it is functioning properly.
What voltage should be found at points ignition on a 1977 XL Harley?
12 VOLTS
Where is the ignition module on a 2003 Harley Sportster?
It is located on the RH side Crankshaft Cover.
Where is the ignition module on 1990 harley fxstc?
On a 1990 Harley FXSTC, the ignition module is typically located under the seat, mounted to the frame. It can be accessed by removing the seat and sometimes the side cover, depending on the specific setup. Make sure to disconnect the battery before attempting to access or replace the ignition module for safety.
How do you electronically reset a harley davison after battery removal?
turn the ignition on and off 6 times.
Does your Harley have to be in neutral to start?
No. My 2002 Softail (Deuce) will start in gear, clutch in or clutch out, if the ignition is turned on.
Where can i get an online Harley-Davidson Motorcycle wiring diagram?
wiring on aftermarket dash mounted ignition switch
Why does your 2000 Harley Davidson have 4 spark plugs?
it has to do with your ignition system. must be t-storm heads off a buell both of which are dual fire ignition systems.
How do you remove a 1998 harley electra glide ignition switch?
To remove the ignition switch from a 1998 Harley Electra Glide, first disconnect the negative battery cable to ensure safety. Then, remove the two screws securing the ignition switch to the fairing. After that, carefully detach the wiring harness connector from the back of the switch, and you can pull the ignition switch out. Make sure to keep track of any screws or components for reinstallation.
