answersLogoWhite

0

The wider the screwdriver, the better. Longer handle will give a fling affect possibly resulting in thrown paint splatter.

ANS 2 - Why not do the sensible thing and just get a paint can opening handle, available for less than a dollar at every paint store and hardware store.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you release a stuck gas tank cover on a Ford Escort Wagon?

Have someone trigger the release inside the passenger compartment while someone else is prying the gas tank cover with a screwdriver.


How do you replace a map light in a 2004 F150?

Map Light If you look at the plastic cover, you should see two notches towards the rear of the cover. Insert a tiny screwdriver or other prying device and gently pry down and to the opposite side of the cover, it should easily pop off. Remove and replace the bulb, and put the cover back on.


Which would a lever be BEST suited for?

prying a manhole cover out of the road


How do you remove the panel to replace the power door lock switch on 1997 Buick Park Avenue?

The question you ask is too involved for a proper answer. You may want to go to a car parts store, or book store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library. 1. Remove the cover around the door handle, by opening the door handle, and gently prying it loose with a small screwdriver. 2. Remove the cover located in the armrest by using a small screwdriver. Remove the two screws located there. 3. Remove the light located near the door opening, by gently prying with a small screwdriver. Remove the one screw located there. 4. Remove the plastic pin located in the defogger air duct opening by grasping with needle nose pliers or by prying with a small screwdriver. 5. The entire door panel can then be lifted up and off the door.


How do you remove the back cover of a Verizon htc thunderbolt adr6400l smartphone that DOES NOT have a slot or gap at the top?

Try removing it with your nail and use your thumbs for leverage. Or, you can try prying it open with a precision (or a jeweler's-type) flathead screwdriver. Once you are able to pry enough of it away from the rest of the casing, you should be able to open up the sides and remove the cover.


How do you remove the dome light cover on a 2001 Honda Prelude?

According to the owner's manual, you pry it off by prying at the front of the cover. Do it carefully


1967 dodge dart you have removed all of the timing cover bolts but still cant get the cover off Need help?

hammer and a screwdriver and drive the screwdriver in on one top corner of the cover between the cover and the block and pry it off, just the gasket and sealer holding it on.


How do you replace a rear view mirror in 1999 Acura RL?

To replace the rearview mirror in a 1999 Acura RL, first, remove the plastic cover at the base of the mirror by gently prying it off. Next, unscrew the mirror from its mount using a Phillips screwdriver. Install the new mirror by aligning it with the mount and securing it with the screw. Finally, reattach the plastic cover for a finished look.


How do you change bulbs in drivers door window control?

Remove the door window control decorative cover. You can do this by gently prying up around the edges of the cover. The light will be visible with the cover off.


Change tail light in 2005 ford freestyle?

After looking at a couple of diy sites, I found that one must: 1. Remove the two screws at the outside back of the tail light cover 2. loosen the tail light cover from the two clips at the front of the cover by gently prying it toward the rear. Fingernails worked for me. The bottom clip seemed easier. If it is too tight, try a screwdriver near the bottom, then near the top prying toward the rear of the car. 3. the top light is the backup lamp (white), and the bottom light is the brake/turn/rear light (red). 4. rotate the lamp 1/3 turn to remove and replace. 5. test. 6. replace the cover by aligning the screw holes then pushing the cover into the clips and replacing the screws.


How do you change the dome light on a Taurus - Sable?

Take the cover off the dome light with a flat head screwdriver. Insert the screwdriver carefully into the small indet in the back of the dome light. pry carefully and the cover will pop off. Pull the bulb out and snapo the new one in. For side bulbs you will need to use a Phillips screwdriver and remover the dome light from the ceiling after the cover is removed.


How do you remove rear deck cover over stereo speaker on 1994 corolla?

With a screwdriver