The only one I found is PIAA 168, try googling that or use the following link below.
http://www.tirerack.com/lighting/detail.jsp?ID=1071&cat=Accessory+Bulbs
Open your trunk and find the wires that go to the bulb over the license plate. Twist the base to remove the light.
look under batteryRemove: air filter boxbattery plate
You can access the bulb for the license plate illuminator by popping the trunk and looking directly behind the plate holder on the trunk-lid itself. There should be a swist type quick release plug that holds the bulb in place. (similar to the third tail-light on models without the spoiler)
how do you change the light bulb over the license plate on 2000 eclipse
how to replace the license plate bulb on a 2004 Honda cr-v
To change the fuse for the license plate light on a 2005 Mitsubishi Diamante, first locate the fuse box, which is usually found under the dashboard or in the engine compartment. Use the fuse diagram on the fuse box cover to identify the specific fuse for the license plate light. Carefully remove the blown fuse using fuse pullers or pliers, and replace it with a new fuse of the same amperage. After replacing the fuse, check the license plate light to ensure it is functioning properly.
how do you replace a honda crv licence plate bulb on a 2004
how do you replace license pate light on 2006 pontia g6
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
Open your trunk the two inner bulbs are for your license plate twist and should pop right out
on an auto transaxle, look (from front of veh.) down close to the fenderwell, under the battery plate. you will find a dipstick handle.