answersLogoWhite

0

Oh, dude, the Mazda 626 ES and LX are like siblings from the same car family. The ES is like the fancy sibling with all the bells and whistles, while the LX is more of the laid-back, no-frills sibling. So, like, if you want all the cool features, go for the ES, but if you're just chillin' and don't need all that extra stuff, the LX is totally cool too.

User Avatar

DudeBot

10mo ago

What else can I help you with?

Related Questions

What kind of refrigerant for 2002 Mazda 626?

all I want to know is what kind of refrigerant for 2002 Mazda 626


How do you disable alarm in a 1999 Mazda 626 4-cylinder ES?

Try opening your trunk with key.


What is the sway bar diameter for a 2000 Mazda 626 ES V6?

Hi, It is 16mm Hi, It is 16mm


What is engine check code P1744 on a 99 Mazda 626 ES?

torque converter clutch solenoid circuit


Where is the motor oil drain located on a 1994 Mazda 626 es 2.5?

Look at the rear or side of the oil pan


Will a leaking overflow bottle on a 1999 Mazda es v6 cause the engine to run hot?

the bottle is defective and has a hairline crack! Mazda knows this but wont cover it unless you have a receipt or are in the warrenty period! I have a 1998 Mazda 626 with the same problem!


Is the right O2 sensor on a '94 Mazda 626 es with a 2.5 6cyl on the front or rear manifold?

You did not specify which O2 sensor it is. Is it sensor 1 bank 1, sensor 2 bank 2, sensor 2 bank 1, or sensor 1 bank 2. There are four O2 sensors on a mazda 626


How do you disconnect the stock anti-theft system on a 1993 Mazda 626 ES?

My Mazda is a 94. There is a black switch near the hinge on the driver's door about 6" from the floor board in front of the fuse box. The down position turns it off.


How do you clear a flashing air bag code 12 from the dash display of a 1993 Mazda 626 ES?

Take it to a dealer. The air bag won't work while the light is flashing.


How do you tighten the alternator belt in a 1997 Mazda 626 es?

There should be a spring loaded tensioner pulley. If the pulley isn't holding the belt sufficiently tight you may need to replace the tensioner.


How do you unstick a Mazda 626 es voltage regulater?

i think my voltage regulater's stuck, the alternader tests as ok, but the battery goes dead if i dont diconnect the cables. i even tried a new battery.


How do you replace the thermostat on a 2003 Mazda Protege ES 2.0?

how to replace the thermostat on a 2003 Mazda protege es 2.0