0
What else can I help you with?
How do you change the clutch in a 1989 Isuzu pickup?
To change the clutch in a 1989 Isuzu pickup, first, disconnect the battery and remove the transmission by unbolting it from the engine and separating it from the driveshaft. Next, take out the old clutch assembly, including the pressure plate and disk. Install the new clutch components, ensuring proper alignment, then reattach the transmission and driveshaft. Finally, reconnect the battery and test the clutch operation before driving.
How do you change a rear main seal on a 1995 Isuzu Trooper?
you pull the engine and tranny out. pull them apart. remove the clutch on a manual or the torque converter on an automatic. then remove and replace the rear main. it's located on the shaft that went into the tranny.
Do you have to remove the engine when replacing the head gasket on a 1999 Isuzu rodeo?
no
How do you removed the crankshaft on 1996 Isuzu trooper?
You have to remove the engine first from the car. Place it on an engine stand and work your way on removing the cranksaft. No way to remove it while the engine is in the car.
Where do i put clucth fluid in the Isuzu Rodeo?
There should be a small resivor by the brake booster on the driver side of engine compartment for clutch fluid.
Installation clutch cable 1990 Isuzu pickup?
To install a clutch cable on a 1990 Isuzu pickup, first, disconnect the negative battery cable for safety. Then, remove the old clutch cable by detaching it from the clutch pedal and the transmission. Install the new cable by threading it through the firewall and connecting it to the pedal and transmission, ensuring proper tension. Finally, adjust the cable if necessary and reconnect the battery.
How do you replace the clutch on a 1996 Isuzu Rodeo?
Make sure you disconnect the slave cylinder and take out of the transmission before you remove the transmission. Remove transmission, remove pressure plate & throw out bearing, and your clutch will fall off. Then just do in reverse - make sure you line the splines on the clutch. You can get an alignment tool from the parts house to make the transmission go in easier.
Is there a switch or fuse to allow ignition on the clutch or clutch pedal of a 1990 Isuzu Trooper 2?
Help me please - engaged clutch - turned key- engine turned over - power and all then died -- restarted - pop and no power as if battery died???? what can I trouble shoot and where to start???? Thanks
Does a 92 Isuzu pickup have a fuse to the clutch starter safety switch?
No
Will a 3.5L 1998 Isuzu Trooper engine fit on a 3.2L Isuzu Rodeo transmission?
will a 3.2L 2000 Isuzu Trooper engine fit a 3.2L Isuzu rodeo transmission
What is the Valve clearance of Isuzu 4ba1 engine?
valve clearance for Isuzu 4ba1 engine is 17.00.
How do you remove headlamps on 2012 Isuzu D max?
how to remove the headlamp on 2012 isuzu d-max
