0
Do you need to get the pistons rings changed when the compression test for your 97 eclipse GT came 135 100 110 125 A lot of white smoke was coming from the tailpipe?
White smoke is an indication of a blown head gasket. Stop driving this car immediately. Although the compression is not great, it is not bad enough to warrant an expensive overhaul. If on the other hand you find that the head gasket has indeed blown, then you might want to just go ahead an overhaul the engine as the head will have to be removed anyway. You will need more than just new rings. the head gasket test came negative. The head gasket is fine. whast wrong with it. Is the turbo leaking oil
What else can I help you with?
What are the different designs in pistons except for cylindrical one and why?
Some alternative designs for pistons include domed pistons, flat-top pistons, and dished pistons. These designs are used to alter the compression ratio of the engine, improve combustion efficiency, and achieve specific performance characteristics. Domed pistons can increase compression ratio for more power, flat-top pistons can improve flame propagation, and dished pistons can reduce compression ratio for better fuel efficiency.
Where is the compression stroke located on a 1997 dodge ram 2500?
The compression stroke is not part of the engine. It is what happens when the pistons are on the upward with closed valves.See link below.The compression stroke is not part of the engine. It is what happens when the pistons are on the upward with closed valves.See link below.
How compression ratio can be increased?
shaving the heads of the motor or enlarging the pistons
What could be wrong if the bottom of the motor loses compression on a 1981 Toyota pickup 22r?
compression rings on pistons are worn out or broken
What does the balance shaft do on a 1999 Mitsubishi Eclipse GST?
It balances the vibrations from the pistons...
How do you increase the compression ratio of a 1996 Chevy caprice94-96 Chevrolet caprice 9c1 police package car?
with higher compression pistons
Will Boring a block incress compustion?
If you're asking about the compression ratio, it depends on the pistons you choose after boring the block. no, the way you increase compression is by using different pistons, an ,or smaller chamber heads. boring a block increases cubic inches.
How do you lower engine compression?
You usually lower engine compression by using head spacers between the engine block and head or by using shorter pistons.
If i replace a head gasket and resurface my head will it restore my compression and make my vehicle start and run?
You will have an improvement in engine performance and an increase in compression unless the compression rings on the pistons need replacement .
What do you need to increase compression on a1990 miata?
Shave the head or change pistons. See Miata.net
What was the compression ratio of a 71 nova with a 307?
The early 71s had 9 to 1 with a 74 cc head and a 1.72 inch valve. they changed the pistons to 8.5. So if your rebuilding an early 307 and its got flat tops in it, its got 9 to 1. If you got dishes or little bowls in the pistons its got 8.5 to 1.
Why won't my talon tsi start with no turbo?
the compression isn't high enuf the tsi's have low compression pistons and are relying on the forced air from the turbo to feed it
