answersLogoWhite

0

You will have an improvement in engine performance and an increase in compression unless the compression rings on the pistons need replacement .

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Your right front wheel shakes when braking at speeds of 50 or higher?

the brake rotors are warped. resurface or replace rotors. if the vehicle shakes without applying the brakes, check tire balance.


Replace Hydraulic Cylinders?

form_title=Replace Hydraulic Cylinders form_header=Find a mechanic that can help restore your vehicle to top working condition. Describe the problem with the vehicle:=_ When was the last time it had general maintenance?=_ Do you need a rental car while your vehicle is serviced?= () Yes () No


How can you convert a vehicle running on premium fuel to run on unleaded fuel?

Replace the head gasket with a thicker one, this would lower the compression ratio.


How do you replace 2007 Mitsubishi outlander rare brakes?

To replace the rear brakes on a 2007 Mitsubishi Outlander, first, ensure the vehicle is securely lifted and supported on jack stands. Remove the rear wheel, then unbolt the caliper and slide it off the brake rotor. Replace the brake pads, and if necessary, resurface or replace the rotor. Finally, reassemble everything, ensuring the caliper is properly secured, and repeat for the other side if necessary.


What is the cylinder compression for a polaris 1996 425 magnum 4x4?

The cylinder compression, for your Polaris ATV, is 14 to 1. The cylinder compression usually decreases as the vehicle gets older.


Engine smoking white after it warms up?

You are burning coolant. What vehicle? did you do a compression test?


how much is it to get brake pads changed ?

Depending on the make and model of your vehicle, to have new brake pads installed and resurface the rotors the cost should be about $200-$225. (Las Vegas rates)


Can i check compression with motor out of vehicle?

Yes, but only if you can crank engine at normal starter speed.


How do you know the Head intake and exhaust are bad?

The vehicle will have low compression causing it to misfire and not run


1997 Chevy Tahoe you took it to a mechanic and was told that the number 6 cylinder is getting no compression and that you need a new engine Can this problem be fixed?

It would largely depend on why #6 has no compression. It could be a minor repair or it could be a major repair. If it is a major repair and the engine has high mileage it would be wise to replace the engine only if the vehicle is worth saving.


What is an engine break and how does it work in a vehicle?

An engine brake, also known as a compression brake or Jake brake, is a system in a vehicle that helps slow down the vehicle by using the engine's compression to create resistance. When activated, the engine brake closes off the engine's intake valves, which restricts the flow of air into the cylinders. This causes the engine to work against itself, slowing down the vehicle without using the vehicle's brakes.


Motor on 1997 ford aerostar 3.0 sounds like its missing and running rough?

I would suggest you replace the Spark Plugs and Plug wires on a 11 year old vehicle. If it is still missing, then remove all spark plugs an run a compression test. If it is loosing collant with no apparent leak, and has low compression on one or two cylinders suspect a blown head gasket.