If they both don't work, check the fuse. Under the dash on the drivers side. Could be a problem with the master control switch on the drivers door? I've had to replace the window regulators and both door switches, one at a time, never both at the same time.
check Mazda forum. Answer is within
replace it
in the hand part where you close the door theres a screw, take it off, pull the assembly from the top by the window switches, when it comes out the wires will follow, disconnect the harness, and replace with the new power switch. (note this is the drivers side)
The door switch is bad. I have replaced the drivers side door switch on mine for the same reason.
The Mazda 626 turn signal relay switch can be found below the dashboard on the drivers side of the passenger compartment. The turn signal relay switch should be labeled as such.
It should be located in the trunk on the drivers/passengers side.
The backup light switch is located on the left side of the transmission. Disconnect the switch connectors, then unscrew the switch.
To replace the hazard warning switch on a Mazda Tribute, start by disconnecting the negative battery cable for safety. Remove the trim panel around the switch using a trim removal tool, then carefully detach the switch from its connector. Replace it with the new switch, reconnect the connector, and reassemble the trim panel. Finally, reconnect the battery and test the new switch to ensure it functions properly.
The 1990 Mazda 323 horn relay switch can be found on the front drivers side quarter panel. The relay switch will be on the inside of the quarter panel.
Generally whenever a switch goes bad the only thing you can do is replace it.
To repair the heater control switch on a Mazda B2200 pickup, first disconnect the battery to ensure safety. Remove the dashboard cover to access the heater control assembly, then carefully detach the switch from its housing. Inspect the switch for any signs of damage or wear, and if necessary, replace it with a new part. Reassemble the components, reconnect the battery, and test the switch to ensure it's functioning properly.